Search results for query: *

I am connecting directly from a Meridian Option 81C Rls 4.5 to a Cisco Call Manager. This is how I have the route and trunks configured now. REQ: prt TYPE: rdb CUST 0 ROUT 51 TYPE RDB CUST 00 ROUT 51 DES GAINES TKTP TIE NPID_TBL_NUM 0 ESN NO CNVT NO SAT NO RCLS EXT VTRK NO NODE DTRK YES...

I have 3 new PRIs which are going into a new route. I have the route and one of the PRIs configured but calls are getting intercepted to the attendant. The route is aquired in Symposium but I'm not sure where else it needs to be set up to give voice treatment. Meridian 1 Rls 4.5 CallPilot 703t...

How can you tell if the Symposium server was install as standalone or coresident for Web Client on SCCS 5.0?

I have card slot 56-1-11 that I can't enable the card that is in that slot. If I plug/unplug the card in the I get the XMI messages, but cannot enable the card. Thoughts?

I'm trying to for an ext(6901) to a 1800XXXXXXX off site. I have tried both ACD DN and phantom DN and they both work if I forward to a local DN using ACOD 9 and LD DN using ACOD 8. 1800 is programmed as an SPN to go out the same RLB that the local calls go out. Any suggestions?

How can you tell if a server was install as standalone or coresident on SCCS 5.0?

I have a CallPilot 4.0 on 703t Platform. When you leave a message it has a timestamp that is 1 hour ahead of the time it was left. The time in the switch is correct as well as the time on the CallPilot server. I also checked that the time zone was set correctly. What else would cause this to happen?

I have a CS1000M that is connected to a Siemens gateway with a PRI connection. I am having a problem with CDR of the digits dialed across this route. Example, one of the steering codes is 2009, where the digits dialed are 200-9174 to reach the remote site. The route ACOD is 8007. When I look at...

I have the CDR & TRF buffer enabled on a Opt 11C working with OTM. When I stat the buffer it shows that it is 62.8% full and is connected to the OTM using Data Buffering & Access. I have run the collection and costing in Telecom Billing System, but it still shows that percentage in the buffer...

I have a MerMail 12.11, in a Option 61C, that fails backups either scheduled or manual. These are the SEER codes that I get: 11-49 6/04 10:37 Admin Inf 1 Null Des: VS1 Starting on-line backup 66- 4 6/04 10:37 Error ** 1 Null Act: Refer to DM Driver error...