Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: Mechjet
  • Content: Threads
  • Order by date
  1. Mechjet

    Trunk Setup in HiPath 4000

    Hello All, The powers to be at my work place have tasked me to setup a new trunk on our HiPath 4000 system. I have a DIU2U card with an open port and would like to configure it for a circuit (with 23 channels). Would I REGEN an existing Digital Trunk and change PEN assignment and what would be...
  2. Mechjet

    AMO Command to change PEN assignments

    Hello, I have about 30 IP phones (420 STD) I need to change the PEN assignments to another STMI card. Could someone please tell me the AMO command to do this. I am trying not to use the HiPath Assistant to complete this task. Thank you.
  3. Mechjet

    Deleting Span From The HiPath

    Hello All, At one of my locations I have two PRI's connected to the DIU2U card. I am in the process on disconnecting one of the circuits and was wondering if anyone could tell me the AMO command of removing the channels from the Trunk Group and deleting the setup of that span from the system...
  4. Mechjet

    Blocking Unwanted Inbound Calls

    I have been asked by my management to find out if there is a way of blocking inbound numbers (bogus calls) on the HiPath 4000 PBX. I found out there is an AMO command ‘CLIMA’ and was wondering if anyone has used it and how to set it up. Any assistance would be helpful. Thank you.
  5. Mechjet

    Polycom IP 6000 Setup In HiPath 4000 V4

    Hello, I am in the process of getting a few Polycom SoundStation IP 6000 conference phone and wondering if anyone has set these up on the HiPath 4000. Any setup information would be greatly helpful. Thank you.
  6. Mechjet

    Siemens Optipoint 420 setup in CUCM v8.5

    I have CUCM v8.5 and trying to setup Siemens Optipoint 420 SIP phones for use on CUCM. Has anyone configured Optipoint phone on CUCM? Any help would be grateful. Thanks.
  7. Mechjet

    OptiPoint 420 Stuck in 'Initializing'

    I have several Optipoint phones stuck in 'Initializing' after they are pluged into the network. Any sugesstions on a repair. I have a HiPath 4000 on ver 4 with several IPDA remote shelves at diffrent locations. It is happening at some of my locations but not all of them. Thanks for your time.

Part and Inventory Search

Back
Top