Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Connecting to Home Lab from Outside
Hello, I am having difficulty reaching my home lab over the internet from outside of my house. I have tried using telnet on port 23 and ports 3000+. In both instances I am able to connect from the inside of my network using the IP address of the interface connected to my cable modem, but... -
Conecting to a 2600 with a bad console
It appears that I have a couple of 2610 routers with bad console ports. I have been trying to connect to these routers through various means and I am at a bit of an impasse. When I boot the routers they go through their boot sequence and then start displaying garbage characters on the... -
2610 Router - Bad Console Port?
Hello everyone, I was basically given several 2610 routers to use for a CCNP lab. One of the routers is giving strange characters during the boot sequence. The hyperterminal session then shows no more input or output. The relevant portion is below: cisco 2610 (MPC860) processor (revision... -
2600 Router - Can't set encapsulation on Sub-Interfaces
I am certain there is something simple that I am overlooking... I am studying for my CCNA, playing around with a few of the dirfferent concepts with my hardware. I am trying to setup a router on a stick configuration using a 2600 router and a 2900 catalyst switch. I have the FastEthernet 0/1...
