Search results for query: *

I have an pc with an internal address 193.33.20.114, (I know an external inside address) and i have an access list as follows... interface Ethernet0/0 ip address 193.33.20.15 255.255.255.0 ip access-group 100 in access-list 100 deny ip 193.33.20.0 0.0.0.255 any (Line 1) access-list 100 permit...

Hello There, Could someone help with a question i have about external ip addresses from ISP's. If i get a range of static external ip addresses from my isp can i use all of these addresses for accessing internal services? For example if i get 200.200.200.185 with a subnet mask of...

Hello There, I have set up my pix 501 as shown below and smtp and rdp connections work but a cannot get the www or pptp for otlook webaccess or remote microsoft vpn connections. This is confusing for me since when i show the access-lists i get a hit count which suggests that access is getting...

Hello There, I have a question about access-lists. I have a running config of a router and i have included part of the access-list as shown below... access-list 100 deny ip 198.33.20.0 0.0.0.255 any access-list 100 deny ip host 198.33.20.174 197.33.20.0 0.0.0.255 access-list 100 permit ip...

Hello There, I have a central cisco 3640 running two leased lines to two 1600 remote cisco routers. Could anyone suggest what would be best for a form of redundancy for this setup? I beleive that the 1600 would only support the one serial WIC that they already have but could i have a possible...

Hello Everyone, I have a cisco PIX 501 and would like to use this at home. Do i need my ISP to supply a perimeter router configured with an outside IP address? And do i need an additional outside ip address for my pix firewall to then route to the ISP's perimeter router? Also, is it also...

Hello Everyone, Please excuse my ignorance with this question, here goes.. I have a broadband ADSL modem which has two connections. One RJ11 connector for the ADSL phone line and one USB connector for my PC. This works and allows my pc on the internet with broadband. However, i now have a PIX...

Hello There, Can anyone advise on what i need to do to set up outside RDP connections to internal microsoft servers. Do is need a static translation? or can i preferably use a single outside ip address and setup port redirection. Regards, Derek.

Hello There, I have a 3640 router connected to the internet on S1/0 on a public IP address configured with the ip nat outside command. My inside ethernet interface is configured to nat the entire ethernet subnet by using overloading on the outside interface...so far....so good. i have a...