Search results for query: *

Have a problem with IP Office 412 rebooting. First I changed out the analog unit that was not getting and dial tone on the ports with a new replacement unit. This fix some of the ports with the dial tone problem but not others but after rebooting the IP Office a few times with config changes...

I get a message when I get incoming calls that roll over to voice mail that say no operator assigned. But if I call the hunt group number directly I get the voice mail message ok. It’s only when getting out side calls coming in. I am using IP-403 and Voice mail pro. Any Ideas? Craig Stewart

I have run into an issue with embedded voicemail on IP406 V2 DS. The problem is after the auto attendant says its announcement and then jumps down to the voice prompts 1-5 that I have set up, after the user hears the prompt and presses the 1-5, there is a 20 sec delay before it goes to the...

I have another problem with my Line appearance lines and when a call comes in and no one answers the call goes to the embedded voicemail in IP 406 DS. After the greeting and the beep to leave a message and the call is gone the line appearance line stays lit for about 2 min's. After that the line...

I am tring to remote in to a IP office and to make life easy I open up the DMZ to access the IP office but still not able to get in. Is there a setting in Ip office that I need to set to allow access from outside the local network? Craig

I new to this so bear with me, I am setting up IP 406 ds with Line appearance on three buttons, and I have them working as far as incoming calls but I can not get dial tone from them to make out going calls as well as the appearance buttons. I can not make any out going calls with the 4 port...