Search results for query: *

How do I create a new dchannel as a primary and one as a backup When I config the dch in ld 17 pdch is not an option

I need to add this card I have no config right now I have the card in cab 0 slot 2 I have done the ddb In load 17 how do I add the card cequ the dlop command do I just chose a loop and how do I refer it to the card in 0-2

Do I need a clock in a Cabinet before the IP trunks will enable the are all disabled now and I am assuming it is because there is no clock installed at this time. Thanks

I have a rel 5 to install is there a preconfigured default database like the opt11 or cs1000s

Body/Solutions In 2007 Daylight Saving Time begins on the second Sunday in March and ends on the first Sunday in November. This pattern will be followed by all US states and Canadian provinces which observe daylight saving time. Previously, the US and Canada had observed Daylight Saving Time...

I had 2 sets an I2004 and a 3904. I built the I2004 first then the 3904. The I2004 was not working and the 3904 would not forward til I deleted the I2004. Is marp causing this and is there a way to assign the 3904 as the mail or how do you control the forwarding on a MARP set.

There is a way to access the IP config on a set without rebooting, does anyone know this ?

What statement in this defines the vlan ID and priority Nortel-i2004-A,x.x.x.x:4100,1,10; Is it the 1 and 10 ?

I just set this up and wanted to give everyone a heads up on serial collection. If you are not using a buffer box and re using otm to collect directly from the serial port you must set otm to 7 n 1 not 8 n 1 even though the switch is set to 8 n 1. If you do not get any records or if you look at...

In ESA when I send 9911 this is what gets sent to the co and fails. If I put in a SPN the osdn does not ring, is there a way to send 9911 from esa and have the first digit 9 strip ? Thanks

Does anyone have a step by step on programming a pri for dms 100 and NI2?

can you reset a mailbox password from the tui ?

What is the CPUB prompt in LD 16 I can find no ref to it.

I have an issue with dial by name it appears the only way to get it is from each mailbox "name dialable by external callers" is there anywhere this can be applied globally to each mailbox. I did not see it it mailbox classes. I am told it can be done in a template but I am unable to find it in...

I have an issue with dial by name it appears the only way to get it is from each mailbox "name dialable by external callers" is there anywhere this can be applied globally to each mailbox. I did not see it it mailbox classes.