Search results for query: *

is it possible with MRTG to obtain traffic only on one interface?.. i am not sure what parameters i would have to pass in snmpwalk... Switch model CATt6509 OS - CATOS Thank you

could anybody guide me in the right direction how to install TACACS+ server on linux. (the instructions would be very helpfull...) i would like to setup cisco swithes and linux server with AAA authentication. thank you

Hello everyone, I have a simple question. What would be the best usage of a Blade Server (Dell PE 1855) I have server handy and I also have a couple of SANs available... Any suggestions?

Hi, I would like to find out how I can reboot the workstation (Dell GX270) remotely using pxe card. I enabled the ‘network boot with pxe’ and ‘fast detect’ on the workstation in BIOS. What command or utility can I use to do so? Any ideas would be greatly appreciated. Thank you,

Have anybody had any problems with jobs starting at some time when it is not specified. My Friday’s full backups begin at random time. The job is set to run at 11PM. But for the past couple of weeks it has been starting previously at 4:18AM and 1:08. And after that the job would begin at 11PM...

My schedule jobs for some reasons are being queued, not always but every other time. There are no other jobs running. Would anybody have an idea why is this happening? Thank you,

Hi, My question is do I have to configure a UNIX agent in agent.cfg file with the actual root password? If somebody has an idea could you please post a sample of agent.cfg file. My job on backup server is configured to run as root but with the different password, not the same as actual root...

Help! How can i block the version of IIS 5.0 displayed when clients make GET requesst to my webserver? ... The urlscan istallation is failing... Any other solution? Thank you in advance.

Hello, How can i find out what Servers are connected to what ports on Cisco 3550 switch. I built an arp table. (pinged the servers). What can i do to find out the mapping of MAC addresses to the switch ports (sh int - shows only switch's ports mac addresses). Thank you

Hello, I am experiencing problem backing up the *nix machines. I get an error: "Unable to attach to SERVERNAME/root Unable to attach to SERVERNAME/root The connection to target system has been lost. Backup set canceled. The connection to target system has been lost. Backup set canceled."...

Hello, In my backup server i get en error: "unable to attach to c:. unable to attach to SERVERNAME\BKUPEXEC. Unable to attach to Shadow?Copy?Components." why does the server can not attach to itself? i can ran the backup manualy and it works fine. Thank you,

Hello all, I have one of the servers rebuilt, and added it to a backup jobs again. It used to have three drive letters (C, D and F), After the server was rebuilt i deleted the server name from the selection list of the backup job and added it again (note: there are only c and d drives are...