Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. tball1

    BCM 450 Rls 6.0

    So you need access to the pep's above or if some one still has them download?
  2. tball1

    BCM 450 Rls 6.0

    Yes i checked the event codes it just says reboot system and contact local support group The hard drive was my first choice for trying to replace any equipment at this time. thanks
  3. tball1

    BCM 450 Rls 6.0

    I have a bcm 450 on release 6.0 has the last patches available thru Avaya issue. The voicemail service stops unexpectedly event code 10102 and 10002 . You can manually restart the service and about hour stops again. Any suggestions. thanks
  4. tball1

    bcm 50

    thanks for your help on this
  5. tball1

    bcm 50

    If the system has expansion modules do you need to connect them up first to restore or can you just load backup on the newer main chassis after installing the patches. thank for your time
  6. tball1

    bcm 50

    can you use the backup from one system same release to another or is their a serial number attached to the backup?
  7. tball1

    bcm450 with multi image Hard Drive error

    Booting up bcm 450 with multi image drive getting error message unable to read bcm450.safeos.initrd then unable to read bmbimage from ide 0:1 does not finish bootup I have attached bootup text file 1 Storage Device(s) found reading bmbImage ** Unable to read "bmbImage" from ide 0:1 ** reading...
  8. tball1

    QPC 841C card in network slot

    Does the qpc841 card just need power from the back plan . Can it go to the right or left side of a super loop card slot?
  9. tball1

    Vantage 12

    I would think that only the vantage handsets would be supported or work on this system . I can not believe it is still working or in working order . I have not seen one since the early 1990's
  10. tball1

    Connecting Righfax open text 2100 to cs1000m release 7.50 using pri

    Got support thru right fax was able to set up as regular t1 esf b8zs and em 4 wnk wnk set right fax to t1 cas setting and right fax needs cas table installed on ther righ fax server for this to work. Don't try ni2 did will not work can not tandem calls or dial outbound with this configuration
  11. tball1

    Connecting Righfax open text 2100 to cs1000m release 7.50 using pri

    I found and old thread thread798-1268715 that references the same problem that iam having solution was design intent. I can not confirm this from listed document 553-2901-100 isdn not sure if any one on this forum can confirm also. I have checked on the Avaya web site but have not found...
  12. tball1

    Connecting Righfax open text 2100 to cs1000m release 7.50 using pri

    I have been trying to get the RightFax open text 2100 to connect to cs1000m I have read several posts on this forum first try was old school with plain t-1 with em4. Appears you get not good documention from righfax . Had it working with ni2 and did internally but could work or answer but could...
  13. tball1

    Install keycodes via dial up modem

    Many thanks bignose21 for the update I appreciate it
  14. tball1

    Kari's law

    Do you know if it is possible to get a merlin legend model 511a to do kari's law dialing?
  15. tball1

    Installing two nt5d12 pri cards

    Thanks for the update on this
  16. tball1

    Installing two nt5d12 pri cards

    Does any one no of limitations to installing two nt5d12 cards in same ce shelf back to back i.e. loops 8,9 and 10,11 is this possible?
  17. tball1

    Install keycodes via dial up modem

    bignose21 if you can find or confirm steps that would be great or any one else for that matter. thanks everyone for the update post. And yes kcflhrc it is to be cautious when entering pdt area.
  18. tball1

    Install keycodes via dial up modem

    bignose21 can you load the license file via ucm this vx works I could not find any place to do it I no you can on co res machine
  19. tball1

    Install keycodes via dial up modem

    kman would be ok if you still got the paper copy of the codes, on the xmodem transfer to cf2 or to the directory location?
  20. tball1

    Install keycodes via dial up modem

    Does any one have the steps to remote in to cs 1000m via a modem and transfer the keycode files I have been using procom to attempt this . thanks

Part and Inventory Search

Back
Top