Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Shaun E on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Search results for query: *
- Users: nelsonherron
- Order by date
-
ILMI fails on 7010/RSP w/ SNMP-3-BADOID: Error
THe issue turned out to be a bad bus termination at the RSP7000 chassis interface. A new CI cured the problem. Had to buy a new router, too, but it only cost about the same as the shipping. Scary how much UPS makes off eBay.- nelsonherron
- Post #2
- Forum: Cisco
-
ILMI fails on 7010/RSP w/ SNMP-3-BADOID: Error
I have gotten a little further than the last time with my ATM/SNMP-3-BADOID: error. It seems that this error is generated when ILMI attempts to start on my 7010/RSP7000 running 12.2.7 IOS equipped with a CX-AIP-SM 155 MM card (73-1188-03 rev B0). The card works properly in a 7007 w/ RP1...- nelsonherron
- Thread
- Replies: 1
- Forum: Cisco
-
"Show running-config" and "show config"
I have books that say the config and the running-config are the same. However, whenever I make changes to the running-config they are not reflected in the config until I "wr mem" or "copy run start". Therefore, I believe it is appropriate to say that the "config"...- nelsonherron
- Post #2
- Forum: Cisco
-
RSP7000/AIP gives SNMP-3-BADOID error
I have a 7010/RSP7000 (no CI) that runs fine except for the ATM card. When I plug in the MM cable from the switch I get a "SNMP-3-BADOID: ATTEMPT TO GENERATE AN INVALID OBJECT IDENTIFIER" message with a TRACEBACK string. It is running 12.1.18 boot and 12.2.7 IOS, 128 MB mem. I have...- nelsonherron
- Thread
- Replies: 0
- Forum: Cisco
