Search results for query: *

I will get the config in the next couple of days. I will be away from the office until then. The recovery time improved by adjusting the timers. Because the wireless doesn't support RSTP, I was restricted to PVST+. Recovery once fibre is restored is below 2 seconds in testing. Brian

Do you need to run seperate VLANs? If not, just run RSTP with default VLANs. We run a similar setup and adjust port priorities to give preference to the fibre link. The links don't load balance, but the fibre carries the traffic until it fails, STP cuts over to the WLAN link after about 30 secs...

Hi, does anyone know if nortel baystack 450-24t ethernet switches support rapid spanning tree? Or is it just a cisco protocol? Thanks, Brian

Thanks for the info, Brian

Simon, Have a look at the cisco wireless range calculator (download from cisco.com). Allows you to try different antenna gains and shows ranges with 10dB fade margins. Brian

Hi, I am looking into doing the wireless test. Any useful information such as sample test questions, recommended study materials???? I mainly work with 350 bridges, which I will soon be replacing with 1300s. They are used in a processor control environment, to link remote equipment to the...

Thanks for the info. I will have the switches in a ring, with stp enabled. I was concerned about the recovery time if we had a fibre break at a point in the ring. I should have said multicasting for a new path, but the loss of traffic is the major concern. So 15 secs is the answer I was really...

Hi, if we have a network with 8 switches (3550 and nortel 450) (at 4 locations) in a ring, how long will the network take to recover from a break in the ring? I have been told a broadcast storm following the break could cause a traffic loss for up to 60 seconds. Is this likely? Any other...

I am receiving little rectangular boxes instead of some characters on some fonts. This happens in word, OE and IE6. Any suggestions? TIA, XP

wouldn't have a url for that would you?

Hi, using the standard nt4 backup, can I configure it to backup to a network drive, not a tape drive which I don't have?

Hi, I have found that defrag is not installed on my server. It doesn't come up in the add/remove windows components, any ideas?

Chris, thanks for your help. Brian

Hi, I had a job interview yesterday where they asked me how would I change which disk the paging file was kept on? Any answers for future information would be appreciated. Also, why would you want to do this?

...Can anyone tell me how much of the config file is relevant to the router? Is there an idiots guide to modem config files anywhere? Thanks, Brian ;********************************************************************** ; Copyright (C) 1996-1998, Rockwell Semiconductor Systems, Inc. ...

Hi, I have a problem configuring my 2520 to dial the internet using an external modem connected to serial3. The router will not talk to the modem. I have included the modem information from the .inf file . All help appreciated. Brian cheetah Modem settings as follows: HKR, Init, 1...

thanks for your help, it worked a treat!

I can't install office 2000 onto my w2k server. I have tried running the setupse.exe file and then installing, but it brings up an error message that I need to consult ORK. I can't find the info I need. All help appreciated. XP

the general rule is to get a pair of 2501 and a 1900 switch. This will cover all topics covered on the ccna.

by different network, I mean connected by routers, or on the same physical network, but a different subnet. I can access another network using http or ftp, but I want to know if I can map a network drive, or not as the case may be. Thanks.