Search results for query: *

All, I just found out that the current working spans are 4ess and not 5ess as my documentation indicated. I'll change the type and see if it makes a diference.

Thank you kat0118, I'll check with the carrier.

Thanks guys for the tips, I have a scheduled cutover next Thursday, this will be my 3rd attempt. I'll turn DCH messaging on and I'll give DSEL 3VCE a try.

Thanks…. what puzzles me is that the current configuration is working with my current carrier, The only variable here is the new carrier T1’s .

I have with new carrier in LD 60 all channels are idle. Using the access code 7002. I get dial tone, I dial a local number NPA/NXX xxxx I imediatly get a reorder tone. LD 80 I use TRAC and the TNB of the set I'm calling from but I only see the set information the number dail and no...

Your help will be appreciated! I have an Option 61C with two working PRI's for local DID inbound and outbound traffic. We recently changed carriers but I have not been able to complete the cutover, when we try to cut the carrier is able to complete the call using a test DID number that they...

I want to thank all of you for your help and valuable input. Yesterday I did an INI on the switch, but the EDD016 error was still there. By the way INI did blowout my recent MAC's. johnpoole reply caught my eye because I did have 2 acd test phones. I removed the acd phones and I was able to to...

I hope that someone may be able to guide me with a situation that I've encounter with my option 61C. I've noticed that LD 43 on the mid night routines is not running, the routine is ending with an EDD016 No Go. Bad Data error, worse yet I can't load any maintenace loads. When I try load 43 all...

Many thanks for your valuable tip unkalary, the T1 loop has not drop once in the last 24 hours.

unkalary thanks for the advice, I think you are right! The treshold settings are setup to low which in turn forces me to restore it manually. I went ahead and change the treshold settings: TRESHOLD SETTINGS BEFORE CHANGE LD 73 – Digital Data Block REQ PRT TYPE DDB PREF 24 SREF 27 TRSH 00...

Hey guys, thanks for all the good tips! So far the problem has not resurfaced, but it bugs me not knowing what caused it in the first place. I don't know how I got into the PRI mentality but the T1 is channelized. 12 outbound ground start and 12 DID E&M wink. The software release is 1/T1

Thank you cowenby for your reply and advice! Great idea! connecting a printer to look at the traffic. The PRI has been in service for 3 years, never experienced any problems until recently. Yes it is possible that all 12 DID trunks could be busy, however, during the times of trouble I've...

I have a Norstar 0x32 in one of my remote sites and over the last three weeks we have experienced intermittent busy condition on all DID calls. I don't believe the trouble has lasted more than 30 minutes before it clears. I've had our service provider test the PRI T1 and of course it test clean...

I hope someone out there on techland can give me directions on how to keep my tie line from dropping. The T1 is disabled every morning and it drops at least twice during the day. I've already had my provider test the line which they tell me its clean. This tie line is between an Aspect ACD...

Can anyone tell me if the Windows 95 PC console software is compatible with Windows 2000. I have 3 PC consoles running on windows 95 that have to be upgraded to Windows 2000 (our current standard) I've asked this question to 2 Nortel vendors and I can't seem to get a straight answer.