Recent content by zee7

Thanks Cluebirdfor all your help!!

show hardware: Cisco Internetwork Operating System Software IOS (tm) C3500XL Software (C3500XL-C3H2S-M), Version 12.0(5.2)XU, cisco WS-C3524-XL (PowerPC403) processor (revision 0x01) with 8192K/1024K bytes of memory. Processor board ID FAB0514V1DM...

I did a sh hardware...and it came up with this. Cisco Internetwork Operating System Software IOS (tm) C3500XL Software (C3500XL-C3H2S-M), Version 12.0(5.2)XU, cisco WS-C3524-XL (PowerPC403) processor (revision 0x01) with 8192K/1024K bytes of memory...

Hi Cluebird, Thanks for all your help so far! The following are the steps I am taking...if there is a question mark next to the command, this means that it is not recognized. config# int GigabitEthernet 0/2 config-if# shutdown config-if# switchport trunk encapsulation dot1Q config-if#...

If I enter the command switchport trunk native vlan1....does it look like from the config I pasted that VLAN1 is the native VLAN. I can email you the complete config if you do not mind? interface VLAN1 no ip address no ip directed-broadcast no ip route-cache shutdown

Hey Clue bird! What I really want to do is setup trunking on interface GigabitEthernet0/2, and I am connecting this interface to a non-cisco device. Any suggestions? Thanks interface FastEthernet0/23 duplex full speed 100 switchport access vlan 74 ! interface FastEthernet0/24 switchport...

Hello, I have a question about the config I have pasted below. In the config below, it says VLAN ISL Id: 1002....but it then states VLAN 802.10. Does this mean that the trunk is running 802.10 or ISL? switch1(vlan)#show VLAN ISL Id: 1002 Name: fddi-default Media Type: FDDI VLAN...

Hello, I have a Cisco switch setup with a VLAN, I have just added a FDDI port. I need to add this FDDI port to the existing VLAN? I then need to setup trunking between the FDDI port and a non-cisco device already setup with a trunk? I was wondering if anyone would have an idea on how to set...

I would like to create a group in Active Directory, which has Local Admin rights to the computer which a user logs onto. I'm not sure how to set this up. I know how to create a new group, but I am unsure how to give that group local admin permissions. Any assistance is much appreciated

I plugged into a hub! Now the NIC is connected. Active Directory is now installed, Thanks Binkin!

No it is not. But the LAN indicator at the bottome keeps saying the network card is not plugged in. Also when I go to ipconfig, I don't have a Iip address. Any ideas. Thanks

I have just installed Win2K server. I would like to setup Active Directory. I use DCPROMO.exe to start this. I fill in Domain Controller for a new domian, create a new domain tree, create a new forest of Doamin trees, enter DNS details, Netbios, I accept database and log locations, I accept...

I replaced the Failed drive. Rebuilt the drive. Created the drive. Formatted the drive. Now the raid is operational Again. It was a Hardware Raid. Thanks for your help!!

I have Raid 1 cofigured over 2 drives. One of the drives has failed. I have the replacement drive. What steps do I take to recover from this. Do I put the new drive in and does it auto rebuild's itself? Thanks

Thanks for all your help guys. This is what I thought!