Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Wanet Telecoms Ltd on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by ysgoh88

  1. ysgoh88

    MD110 PCM LINKS VIA TCP/IP

    Well,PCM-link through ATM switch i have done it. Still is via IP but is a permenant connection with configure by the ATM switch supplier.On MD side the GJUL and GJUG both are connected to the E1 card at the ATM swtich.
  2. ysgoh88

    Hi again, How can I set up a voice

    better way is to restric from the traffic matrix. is very easy. just need to make sure that the traffic matrix is just for incoming.
  3. ysgoh88

    How can I change the NIU EIC ?

    You can refer to the 1 of the tread there, limbabwe is telling people how to erase the eic and write again. It is tested can be done.
  4. ysgoh88

    digital key system telephone ITYPE 2

    you are welcome
  5. ysgoh88

    digital key system telephone ITYPE 2

    what version of software for the pabx? do you program ODN2?
  6. ysgoh88

    Site Code and Cli across DPNSS network

    what the parameter you using for route and extension?
  7. ysgoh88

    How can I change the NIU EIC ?

    if the license is written before in the NIU the you will not be able to rewrite. The EIC will only can write one time.
  8. ysgoh88

    Handover-Problems with FW R6A on ELU31

    How about the syn cable connection? do the ELU 31 all connected with the syn cable?
  9. ysgoh88

    fault code 300

    ask the switch to check on their line..there are no signal to indicated the trunk is seize.surely will be the seting on the AXE.
  10. ysgoh88

    Data Performance Manager - is it really trusty ?

    my office have 1 and it quite reliable.of cos all of this is just estimation..so no 100 accurate.
  11. ysgoh88

    Conference Beep-tone on MD110

    you can request the patch from ericsson itself.
  12. ysgoh88

    Conference Beep-tone on MD110

    actually that is the optional thing. there are a O&R patch for that..you can't just change that as what you want and will not be able to see that.
  13. ysgoh88

    Data Performance Manager - is it really trusty ?

    well,actually the DPM is the traffic measurement from MD. Just the same as we using command to initiate for traffic measurement and print it out.the different is just DPM can put it into graph or chart.so it should be trustable
  14. ysgoh88

    MD110 connection to An other PBX via LL a CISCO

    then you can just used E&M tie line,and more easy for test.
  15. ysgoh88

    MD110 connection to An other PBX via LL a CISCO

    You can used E&M tie line or Q-sig tie line to tie with the cisco at both side.this should work and cisco router should be able to provide this.

Part and Inventory Search

Back
Top