Recent content by Y0m3r0

Hi there, im having a wierd problem with and encore networks reciving an E1 connected to a MICS T1 card, everything seems to be working ok, calls get in and out, but we've found around 4-5 locations that for no aparent reson, they just cant call in, nobody else has this problem, just this 4-5...

Tried with a new power supply same result. The 2 ports that go to call pilot are ok, i plugged in a digital set to each one and they are fine. Any other ideas? or is call pilot dead? Thanks.

Thank you, will try that.

Yes. It just keeps sending that over and over. IF i press a key as it says it asks a few questions and starts again : CallPilot 150 Boot Loader V1.5.19 (C) 2001 Nortel Networks -------------------------------------------------------------------------- NETWORK INTERFACE PARAMETERS: IP...

Hi there, for no aparent reason call pilot stoped working, Feature 983 returns "incative feature", cant connect to it via ip, so used the serial port, and this is what i get over and over : CallPilot 150 Boot Loader V1.5.19 (C) 2001 Nortel Networks...

Is it posible on a CICS ver 7.0, for someone ( lets stay the operator ), to annonunce a call via speakerphone to an internal phone ( T7208/T7316 ) while this extension is in use with a local/external call? We've tried page, but if the phone is in use, it doesnt hear the annoucement. Thanks.

Indeed F **ADMIN did the trick! Thanks!! :)

I'll try that... thanks!

Im installing a 6x16, and im going to config menu ( **266344 ), and first of all it doesnt ask me for password ( 266344 ), it goes directly to 1.Lines, 2.Sets.. etc.. isnt supposed to go to A.Configuration, B.General Admin, etc... first? So im unable to change the date, set names for the...

hehehe just figured i posted to the wrong forum... thanks.

Im installing a 6x16, and im going to config menu ( **266344 ), and first of all it doesnt ask me for password ( 266344 ), it goes directly to 1.Lines, 2.Sets.. etc.. isnt supposed to go to A.Configuration, B.General Admin, etc... first? So im unable to change the date, set names for the...

Yeah.... IRAD was not enabled. me bad.

Nevermind, i figure it out. Thanks.

Im trying to to connect via the remote Set tool to a cics 6.0 irad, and after succefully connecting, and going into programming menu ( Feature **266344 ), i only get the software keys menu, any ideas on what could be wrong?

Im using CICS - SIP 6.1 FC Rel 01