Recent content by xRealistx

Hi, Sorry for the very extended delay in my reply, but I've changed email addresses and only know I remembered to change this one :) Anyway, yes the manual was received 110% and done the job well. Regards, brian

Have you checked permissions? do you have the right to print via windows for that printer? Manualy add a printer port using the printers IP address and go from there. Regards, Brian

I purchased one from this link on ebay:- http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=2085135524&ed=1041790650&ssPageName=ADME:B:EOT:US:3 regards, Brian

Try this direct link M8 http://www.eta-sda.com/certification/Rollover.htm Regards, Brian

Hi All, I have a Tektronix 740 and I find that from the time I press print to the actual finished print, its taking on average 3 mins to print? Is this normal or can I speed up this process. Thanks, Brian

You say that once you have the A+ and N+ you can apply for the CNST. It also states in the very first post that you can also get the ETA-I CNST. Whats the differance between the ETA-I CNST & CNST. Regards, Brian

Hi All, Glad I found this forum, great source of information here. I have the tek 740P and when It starts up the rollers at the rear door that drops down (the one by the ink cartridges) sounds very loud and I thinks could do with a bit of oil. Also......... When it starts to print I get...

Hi All, Glad I found this forum, great source of information here. I have the tek 740P and when It starts up the rollers at the rear door that drops down (the one by the ink cartridges) sounds very loud and I thinks could do with a bit of oil. Also......... When it starts to print I get...

Are these certs valid in the UK? if so how can we brits get hold of one. Im A+ N+ and MCP Regards, Brian