Recent content by xizrax

Thanks micker377 and Ski, I installed the driver just as u described.But After I Turn on the printer when the'printer port' option appears it detects the printer and some pop ups like building driver information database........and i250 driver installed messege appears, but in the printer...

I can't print with my toshiba laptop[ P1, 32MB RAM, Win 98]. My printer is Canon i250 USB. The driver is installed but showing error messege like' cannot detect correct port'when I try to proint. There's no option of USP at Control panel>system>device manager>ports. only USB to parallel and LPTs...

My Toshiba Laptop[pantiam 1, 32 RAM, Win 98] don't have any CD rom drive, SO I want to transfer data via network from my desktop. My desktop is P4 and Win XP. Is it possible to connect my Laptop with the Desktop only with a USB cable? Does USB flash drives work with win 98?

I've tried the Maxtor as stad alone on the IDE, It wasn't detected when set to master,but when I set it to slave, it was detected.And I've disabled the 'quick memory check...selftest'option in BIOS.If it's enabled, the drive is not detected. Again I tried it with the "Bigfoot"; setting...

when I try to install my Maxtor 20GB HDD[model#2b020h1] as master the BIOS don't detect it and during the detection process a "tic tic" sound comes from the disk. But when I attach it as slave with a Quantum Bigfoot 4GB HDD[this disk is set to master then]the BIOS detects the Maxtor as...