Recent content by Xelha

Thanks. I will try getting this done. Kind regards, Xelha

Dear Vlan52, Thanks. Using syslog is - in my case - the best way I guess. I was hoping not to need this because of the additional load on the network, using and maintaining a separate syslog server, unexperienced helpdesk and some other reasons. But again - it is the best way I guess. Now I...

Dear Vlan, I need this for management. I want to know when ISDN comes up, connect to, disconnect and idealy : connection time. Kind regards, Xelha.

Dear Vlan, Thanks again for your support. The MIB you mention does not support 2600 Cisco Routers and supports other devices only with IOS release 12.0T or later release of 12.0T. Unfortunately we use a lot off 2600s and the suppored routers we have are not all using the required IOS release...

Dear Forum, I am using NNM 6.1 on Sun Solaris. Our devices are Cisco. We are using ISDN as Backup for the serial lines. What I need is a MIB for ISDN which gives me information on ISDN Connect/Disconnect, Calling/Called number, Connection Time etc. Does someone has a suggestion which MIB to...

Dear Vlan, Thanks again for your support. Regards, Xelha

Dear Vlan, It works!! Thanks for your support. Kind Regards, Xelh Netherlands

Dear Vlan52, Thanks for your support. I think that I configured sendmail properly. Since it can forward messages to my exchange domain. That works fine. What does not work is sending email with event details as a automatic action in NNM. The automatic action (i found this on this forum)I use...

Dear Mike, I know about the automatic action. I use automatic actions for various events - but I could not get it work to send email notification about events. Kind regards, Xelha

Sorry, I meant Catalyst 3000 /3100 instead of 3xxx. Kind regards

As from version 4.2 Cisco View does not support Catalyst 3xxx anymore.

Dear Forum Members, I am using NNM 6.10 on Sun Solaris. Is it possible to send out E-mail notifications - in case of particular events - with NNM without installing add-ons like Telalert? Or, Do I always need add-ons? If it is possible without using an add-on, can someone tell me how to do...

Dear Forum Members, I am using NNM 6.10 on Sun Solaris. On a lot off Cisco Routers we are using ISDN as backup for the Serial line. How can I get notified if ISDN changes from Backup mode to active? And in General: How do I monitor ISDN lines? If someone can give me the answers. Thanks in...

Dear Friends, I am using LMS 2.0 and want to use Mail Notification through Device Fault Manager (DFM). In Device Fault Manager -> Administration -> Fault Notification -> Mail Notifier, one have to configure DFM Mail Notifier. I have a (rather stupid) question about the Sender ID field: WHAT...

Dear Friends, In Cisco Works LMS 2.0 the User Tracking table is missing hostname, IP address and subnet for all hosts. There is a router involved but CW2000 has no CDP/Snmp community string access to this router. The reason that CW2000 has no access to the router is because the WAN is managed...