Recent content by wwalls

there are other factory installed admin passwords on these switches. try either diag or manuf as the username and danger as the pw.

try deleting the jcache files after closing IE. restart Oracle Apps and they should be recreated. I think the path is c:\Program Files\Oracle\jinitiator\jcache Hope this helps, Walter Walls

I'm sorry, that was SCSI data underruns, not buffer underruns.

I have removed the old tape config files and I had to use the information from caldera to completely clean up. I now have just one tape drive configured and it is responding to commands. Now i am getting buffer underruns and I/O errors writing the tape. Can this be caused by bad tapes? Is it...

I have become baffled. How can I completely remove all vestiges of this tape drive and re-install it?

I shouldn't be running out of tape. These are 12GB tapes and I have less than that used on my whole system. Have I set the media values wrong?

to stanhubble: # cat /etc/default/tape | tail -2 device = /dev/xct0 curdriver=Stp1 #

this is what I get with the tape status command. # tape status status : beginning-of-tape soft errors : 0 hard errors : 2 underruns : 1

find..... | cpio .... > /dev/rStp1 find.....: not found /dev/rStp1: cannot create This is the result...

from cron I get cpio: can't open device /dev/tty for writing cbackup : Backup NOT recorded Backup arg from Crontab: 30 19 * * * /usr/lib/sysadmin/cbackup 0 12000000 /dev/rStp1 /dev/root block size I set from backup manager 1024 volume size 12582912 (12 GB in K) When I issue a tape command or...

I have a Compaq Proliant 1600 with a Compaq 12/24GB DAT drive. The system seems to be able to address this device, but I get errors while backing up and trying to read tapes. I have tried to set it up as a generic SCSI tape drive and also as a DAT drive (compressed and uncompressed). Neither...