Recent content by wormer

Thank you again for your valuable insight. This looks to be the way to go. I feel confident enough to do the replacement (built my video editing workstation from scratch using spare trash at work). My only concern is locating the part. So far, the only place that I found that has one says...

Thanks again. Found this out as well.

Thanks for the response. I have tried to reset numerous times to no avail. The engine controller board... Sounds like only a service tech can replace, or are there places where I can obtain an engine controller board? Thanks.

How do you determine if the Fuser on my Tek 780 is either 110v or 220v without removing it first? If you have to remove it, where on the fuser will it tell me? Thanks

My Tektronix 780 has a "replace fuser" message on the display. The fuser was replaced with a brand new one and the Fuser Life Counter was reset to zero, but the "Replace Fuser" message continues and the printer refuses to work. Could there be a problem with the entire C/D...

I've used the 780 extensively at work. We then added the xerox 1235 and now replaced the 780 with the 7700. Both of the xerox's printed extremely faster but I haven't been able to match the colors worth crap. The 780 was slower, had tendancy to jam if overused, and had smearing probs if...

got to: http://office.support.xerox.com/srvs/cgi-bin/webcgi.cgi?new,ques=User_Type:4,templateset=xo_legacy,kb=out98pkb,ques=obj(69892)::obj(707),ques=obj(34668)::obj(61432),Company={5AC8CA72-62D5-4658-8D6F-D2F393C98A63},varset,prod:790 Then hit problems with printing then the next 2 top...