I Have a dell optiplex GX150 running WIN2000 Pro SP2 and as its a SFF model I have had to use a USB modem (Smartlink).
The modem installs ok and works fine. However everytime you reboot the pc and then try to connect via the modem, it reports as "unable to establish connection". I then...
HI
Thanks for your replies.. After reading some of the other posts I realised that it was the normal.dot template that needed changing, but thanks for the confirmation
Cheers
Wookie27
Im sure there is an easy way to do this.. but I have not found it yet.
When Word starts up the font automatically defaults to Times new Roman. Can you configure Word to automatically start up using a different font type / size etc.. ?
Hope somebody can help with this. For the past year or so I have been connecting my digital camera via USB 2.0 to upload photos etc.. This has not caused a problem before and it correctly creates a removable drive volume F: each time its connected, which I can then access its folders under.
I...
If I have understood your post correctly then I am confused as to why you have got a another default route pointing to 10.4.5.0 ?. When you create IP addresses on Vlans, routing between them is automatically turned on.
Therefore from what you have stated you already have a vlan within the...
I think the default is 25 Seconds. If you look at the TFTP values on Sitemanager, it has a retry timeout parameter of 5 seconds which specifies the number of seconds TFTP waits for an acknowledgment before retransmitting the last packet. And a retransmit value of 5 which is the number of times...
I take it you have a quad ISDN card in your ASN. If so you have to create a bandwidth pool in which you place the other ISDN circuits. Then for your initial demand circuit you click on the BOD "Bandwidth on demand" button on thedemand circuit definition and choose the bandwidth...
Check that the port you are trying to enable diffserv on is not a member port of an IP filter already.
If it is you have to go into the filter itself into the port members tab and disable the port there. Then go back and change the diff serv settings on the physical port.
Finally go back into...
What I would suggest is that you just put a single word in as a interface name eg Test1 with no spaces , save the config and reset it and see if it appears. Or if you need more than one word to describe it use an underscore eg.
Test_name1.
Try this and let me know if this works
If You have the Ip addresses showing then its not going to be a default config issue. What Accelar model are you using and what is the software version.
Something at the back of my mind is telling me I may have had a similar issue a long while back when the boxes first came out. I belive...
Are you saying that there is none of the info you entered in the config? if so...
Make sure that the factory defaults flag is set to false. When it starts to boot it will prompt you to press any key to stop autoboot.
Press any key and it will take you into the monitor mode
monitor>
then...
Just to add to this thread... at present SMLT is a propriety protocol to Nortel.. Therefore you can only run SMLT between two Nortel switches which support it.
However MLT is a standards based protocol (though it goes by different names.. Cisco call it EtherChannel I belive) which you can use...
Sorry forgot to mention that its outlook 2000.. I ahev seen another thread relating to this problem but that with Outlook 2003. The fix they suggest there indicates that i have t set up a HTTP server though i do nto seem to have this option on 2000.. or if I do I cannot find it
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.