Recent content by Wini

No we haven't reset the devices yet. Link-Leds on all devices are ok, users can work. We only have trouble with managemnet of devices. I noticed also that the "show runn"-command shows the following wrong eapol-commands eapol port 1/15 status authorized traffic-control in-out...

Hello Nortel-folks, we have a serious problem with BS470-stacks of different sizes using SW-version 3.5.0.58 It happens that the stack looses its configuration of all units beside the base-unit. The result is thatwith device-Manager only the base-unit is colored. With Telnet, only infos...

In case You forgot Your password on a BS420-24T, simply connect a cascading cable to the two ports of the same unit. After a reset You can connect to the device via Web without Userid and Password.

Hello Nortel-freaks, I need to know whether poor-man's stacking between two BS420 is possible with using only one cascading cable. I have two devices here that do not form a stack correctly and I fear it is because I use only one cable. The devices are using the following Software: HW: # 21...

Hello Nortel-freaks, I have a problem with a recently upgraded stack of 3 BS450: Using SW-release 4.5 now, the stack is longer manageable using the latest available release of Device-Manager which is 5.7.9. The device appears correctly in size but the picture is greyed completly. Apparently the...

Hello, we have same problem with BS450-48T-stack of 2 units. Unit 1 has a Gigabit-uplink to the core and to a WAN-router. Unit 2 has a 100-Mbps-FX-module to connect to another BS450-unit in a second closet. The problem appeared after upgrading the ports from static 10 Mbps Half-Duplex to...

Hello Nortel-folks, I would like to upgrade a BS470-48T HW:#04,FW:V2.2.0.1, SW:V2.2.0.14 with the latest BoSS3.1 stuff. But I'm not sure which file to load first. Is it the image or the diagnostics file in that case ? 452908 Oct 07 2003 bs470_boss3005_diag.bin 1926006 Apr 16 08:35...

Similar problem with BS470 and latest BoSS3.1 We also loos ICMP-connectivity to this box from our Netview. WEorkaround is to use a smaller subnet-mask to force the packet via the next router. Apparently an ARP-cache-issue. Error-messages appear as following on the console-port: BayStack 470 -...

Hi Rick, as far as can rememeber we have installed some of them, but some failed to load. But the systems we receive this new trap from are only BS450/BS350 not BS470!

Hello Netview-specialists. I hopy You can help me with the following misinterpreted Nortel-trap-problem on our Netview V6.0 Nortel BayStack 450 systems with SW-Version 4.4 send our the following trap randomly: SNMP: ----- Simple Network Management Protocol (Version 1) ----- SNMP: SNMP...

Hello Bay-Networks specialists. I hopy You can help me with the following misinterpreted Nortel-trap-problem on our Netview V6.0 Nortel BayStack 450 systems with SW-Version 4.4 send our the following trap randomly: SNMP: ----- Simple Network Management Protocol (Version 1) ----- SNMP: SNMP...

Where can i find introduction to Crystal Reports