Recent content by weinmatt

I did try to restart the vm services. Strangly enough the client now reports its working. So just can't get into manager now. What is this password reveler program? Just an password program that exposes the password behind the ******? Thanks.

I have a client with an older ip403 running version 2.1 (15). It has been running stable for many many years. The user just called saying they get a busy signal when calling into the voicemail. I checked and the services are running on the server. I opened manager and typed in the...

Both of the front power lights are also flashing.

I have a Cisco 1841 router that seems to have crashed. The CF and AIM light are both blinking. The network ports and wic card have no lights. I can no use the console cable and hyperterminal to get to the device. It seems totally frozen or crashed or dead. Has anyone seen this happen...

I just got it fixed. Thanks.

I was changing the config to allow remote desktop to the server and somehow disabled the internet access for the client workstations. Below is my configuration. Thanks for the help. Result of firewall command: "sh run" : Saved : PIX Version 6.3(3) interface ethernet0 auto interface...

I just setup a brand new Partner ACS 8.0 with a voicemail PC card small. Everything on the system is crystal clear, except when I call into the voicemail. When calling into the voicemail I get a very annoying crackling/staticy sound. Has anyone encountered with before? Could it be a bad slot...

I am trying to send a customer instructions on accessing their voicemail from outside the office. I can't seem to find the instructions online. Can someone please post them or a link to them. Thanks.

I am trying to tell the system where to go when someone hits option 0. I know its not a selector code. Right now, it rings only extension 10. We would like it to ring all the extensions. Thanks!

I have a client that is upgrading from an R3 to and R8. Is doing it manually the only way to do the upgrade? Thanks.

did a vmpro reinstall and it started to work thanks

Thanks, I got it working. Now i'm onto voicemail where i'm having an issue getting to the AA from the main hunt group. I have started another post. Thanks for the help.

I am having trouble getting calls for my hunt group to go to the AA. I have set it to night in manager and put in a route by call status in vm pro. I have voicemail on in the hunt group. Do I need to do something special. In the older 3.2 software it just seemed to work. It just goes to...

I am looking to setup short codes for secondary dial tone. I am on the newest release using an IP500. I have not worked with any 4.0+ system before this install. Do i put the short code only in the ARS? When I put the short code only in the ARS using 9N Dial Nsiournumber Line 0 (pri) When...

I just switched out the crossover cable and the speed has not changed. I am getting about 800kb/s down and 1400kb/s up. I'm not sure why the down is so much slower then the up? Anything in the config that it could be. I have cleaned up the config a bit. Here it is again. Thanks...