Recent content by wayneker

It was a CatOS, I tried the command and it gave the message 'Cannot change the state of the default vlan 1002 VTP V2 mode will have to be enabled in order for tr vlans to work properly, configure this vlan anyway?' Any Ideas? Thanks

It is CatOS, I tried the command and it

How do I disable vlan's 1002-1005 on my Catalyst Switches?

How do I create a seed Device in CFM?, all I get is 'unrecognised device' please help

How does a Cat2924xl handle UDP packets?

Yeah, I'm using Uplinkfast on my access switches and its superb, I also have internal Routers on the cat55509's, with MLS enabled, their is no delay at all on the routing now, and its fairly straight forward to setup aswell.

Yes that makes sense, thanks for the reply, a great help.

Yes it is the root

I have a Cat5509 connected to a Cat2948G, ports 1 & 2 are port channelled as are 47 & 48. On the Cat5509 spantree says both portchannels are in forwarding, however on the 2948G spantree correctly displays that one portchannel is in blocking any ideas as to why the 5509 is not displaying the same...

thanks alot

Does anyone know of a cisco TFTP software download that works with win2000? any ideas?

I appreciate that I have connectivity if my ping is returned, but I my Inside users cannot gain access to the internet through IExplorer, The inside hosts appear as 10.180.97.13/22 on the outside interface, all other hosts on the outside, in the same network range have internet access.

Yes its a private address, so as I have 4 hosts gaining access out to the Internet using a PAT address on the outside (which is still in a private network)I cannot ping any of the hosts from the outside without using static NAT's? that means I would need more addresses if I just wanted to test...

I can ping from my inside router and hosts but not from outside hosts back in, i have done a clear xlate, I'm using pat, logging shows the translation working but my router and hosts are not returning the ping according to the logging

Thanks a million for the top tip, I suppose with NT clients this isn't possible?