Recent content by wattie29

Thought so. Cheers Anyway.

Thats great mate except that there is no 'clock' command on the 3.6.0 firmware. Any other ideas?

Anyone know how to set the timezone on a 470 running firmware 3.6.0. Can syn with SNTP server bit the switch is an hour off as I can't set daylight savings or a timezone. Looks like you can in 3.7. Any ideas?

Hello All, Have a LAN to LAN VPN tunnel configured between a Cisco ASA 5505 and a Cisco 877 router. I am tunneling three subnets down the tunnel and all is working fine. Except that at least once a day the link will drop for approx. 1 hour and then recover itself. It only happens on one subnet...

I have two PC's trying to connect to the same PIX firewall via a Linksys WAG54G. Sadly this doesn't seem possible, only onr client can connect at a time. Anyone know why and how we can overcome this issue?

I am installing VPN remote 4600 phones. I have configured them and they work perfectly on PIX 525/515 on PIX 6.3 or 7.0 software but they will not work on PIX 506. I get a IKE configuration error and the PIX debug reports that the IPv4 address is denied. The configs are identical apart from...

Just doing my first PIX install, trying to set uo the remote access VPN but is seems to need a 3DES/AES activation key. Any ideas how I go about getting this?

We are installing a system for a government agency. Their service provider (NTL) has given them the ability to trace calls (bomb threats etc) by sending the following information down the d-channel. Recall *38#. We have experimented with speed dials etc but this only generates DTMF tones on the...

Is there any security MAC address etc that I can use on the Cisco 837 to prevent unautorised access to the ethernet ports and the VPN tunnel. Any ideas?

Thanks guys that was it, removd the dns entry and the 'import all' worked. Do you know if I can VPN tunnel this into a Cisco PIX 515?

The ISP does not provide DNS addresses to us, they are allocated to the router when the connection is established, a kind of DHCP I suppose. I though the 'ip negotiated' and the 'ipcp dns request' commands did that.

I am installing a Cisco 837 at a small remote office, I want to get an outside IP address and DNS from the ISP and also run a DHCP service for clients connecting to the router. Apart from the DNS the config works well. Has anyone got an suggestions? Also can you connect a VPN tunnel fro a 837 to...

Worked perfectly. thanks mate.

Yeah mate UDP.

We have a problem at a remote office wherby only 1 person can connect to the VPN at a time. I believe this is due to NAT to a single IP Address. Does anyone no if using a Cisco 837 instead of a standard adsl router will overcome this issue. Any advice much appecieted. Cheers