Recent content by vz1518

The following error (W3SVC) has been preventing me from using web sites on my server, how do I fix it. I have followed all of MSDN's advise and still no luck. I have done the following without any positive results: The following information occurs in the Event Logs: Event Type: Error Event...

Sorry guys: This is not a reqular p/s 2 mouse. The amarda is a laptop and I do not currently attach an external mouse. I am using that small mouse key that is located between the G,H&B keys. And yes, I am fully aware of the rough surface. Also, when I attached an external mouse it freezes...

Oh Sorry man. I did do that prior to my previous message but I went a head and adjusted it anyway and it seem to go more erattic after that. So I am about at my wits end with this one. cl

I have a Compaq Armada system that seem to have a virus. I scann (with Norton) and I get 0 viruses found. The problem is when the system is booted the mouse works for like five minutes soon thereafter it starts to move all over the screen by it self. I know that it must be a hardware problem...

I am getting the same problem with Exchange Enterprise 2000. Users can send messages and it gets delivered to the whomever it is sent to but the replies is not comming in.

OK I did some investigation on my PDC and found out that (eventhough it was not reporting a failed service) it had numerous failed services. Failed services in the Event Viewer are as follows: NetLogon with Event ID 5775 Deregistration of the DNS record 'domainName.com. 600 IN A...

I am currently running Service Pac 3 This is a single domain but I have a DSL router that gives me acces to the Internet. So I have natted IPs for the local addresses. I have not set up DNS on this server that is Failing. I have though set up DNS on the Domain Controler. And I must say that...

After installing a server and have it Join the domain during installation the server will not join the domain again after reboot. Each time I try to log on to the designated domain I get the following error message: The system cannot log you on due to the following error: RPC Server is...

I have a Win 2000 server running MS Exchange 2000. My win 2000 professional clients are able to access MS Outlook without a problem but my XP Clients cannot. XP or XP Outlook allows me to set up the outlook client and authenticate the assigned user. But when I try to open outlook using one...

To all that Responded: Thanks for all your advise. I was able to sucessfully configure my router and DHCP Server over the weekend. The problem was when I changed the Default IP Address (192.168.1.1) I did not include it as an IP in my list of DHCP IPs. So the fix was to use the same range of...

I rebooted the router as suggested but unfortunately it did not release the IP address back to the default. I tried to Ping the 192 address but got destination time out response. I am about the try all the other suggestions and will report my findings. Thanks. cl

Thanks Old Man. That sounds like a winner. Will try it this week end and let your know what the results are. Thanks.

Hi Mikey: Thanks for your response. But I am not sure I understand your question. I am not sure about a console port on the back but I am sure that the default IP address is 192.168.1.1. I don't use telnet so it must be a port but I am not sure and today I am on travel so I cannot look at it...

Hey Matt: Thanks again. I currently have a Linksys DSL 4Port Router.

I changed the default static IP on my 4Port DSL Router to a static IP from MY Local Network. Unfortunately when I tried to access the Web Interface through the using http://192.162.1.1 (default), I cannot get access to my router. I tried using http://10.10.10.1 (New Static IP) and I still do...