Recent content by vtec

Hi guys, Anyone old enough to help me with a Definity flashcard? I need to know how to flash an upgrade card. I allready have the FW file and need to know at least the following: - what filesystem does the card use - or what tool can I use to flash the card? Any help/hints/tips much...

Well.. I fixed it! Turns out the xml files needed for the xen configs were corrupted. Deleted them, then restarted the XM's and all is fine...

Well.. just setup a test rigg and it just works. SES R5.0 running on an old S8500B works fine on a S8300 running CM6 (evolution server). Oh well... it's just not supported ;-)

You will need an AES server to start with!

Well, basically if you got a test number from your provider and your PRI is connected and up, you should be able to dial the test number and make an incoming call. That is to say, your installer should have provisioned this ofcourse. You should also be able to make outgoing calls, depending on...

Unless you're experiencing problems or the FW of the MM's do not support the CM version you should be OK. Btw check the HW version of the MM710, I know there's some issue with v10 I believe (check support site).

Nope, not supported on CMM. What do you need to do with faxes? CMM supports faxes on t.38 and delivers them to your mailbox. You cannot forward them to email natively, but there are plenty of tools for doing so (popcon for example).

Also, try the basic stuff like transfer/conference. Check numbering format on your display and when using IP phones, check your call log for correct entries and being able to use callback from the log. Test the internal phonebook of the IP phones and check if backup/restore works on them as...

Yeah I know its not SUPPORTED, but that doesn't mean it will not work. So the question is has anyone actually tried this...?

Anyone had this issue? After a (forced) reboot the sdom isn't starting and therefore the rest of the VM's neither. Only cdom is running and is accessible using root access. During boot I get an error that XEND isn't running. XM shell is working, XM list gives an error along the lines of 'unable...

Anyone tried to use the 'old' SES on a new CM6? Only for SIP trunks, nothing special, should work should it not?

Hi, Anyone familiar with the BT DASS2 protocol? And is there someone who can tell how to (or how not to) hook it up to an Avaya Communication Manager using the MM710 card? Thanks... David

Hi, I'm trying to connect a T1 trunk to an Avaya Communcation Manager (rel 5). Can anybody help me with the correct config for DS1, Signaling and trunk settings? Currently the trunks are connected to a Nortel system using the NT7B74 board, which supposedly is T1. I have no idea how to configure...

Hi, Same here, according to the manuals you can only enter an accountcode before call setup. If you have found a way to enter account codes on incomming calls, please share! ;-)

Hello, I'm currently trying to build custom reports (using screenpainter, yes I know, but I need to have reports in text format) and I need to have a realtime report to show the servicelevel for a certain skill. But like in an integrated report, so from the beginning of the day up to the moment...