Recent content by vsop345

This is happening on all phones with VM not just the ones with cover.

Yes we are using the AA. Ken1713, yes we have two phones that cober for other ext,ie, 8600 covers for 8615 and 8611 covers for 8613 and 8614,

It is a Merlin Magix with Merlin Messaging (1.1). It want for VM box for that person to pickup by the fouth ring.

The problem I'm having is outside calls taking about 6 rings before going to voicemail. The cover delay has been changed to 1 but I still get same number of rings. Any suggestions???

Something else I just found is in Winspm system inventory it shows as "no fw". I assume that's firmware. Also, in maintenance status the mode shows nothing and R is on.

This board is in slot 2 and in slot1 is another 024tdl. Slot3 is a gslid. This is the same configuration we have had since getting the pbx.

We recently had repaired a 024tdl board and it has been installed for about 10 days. Curiosly, somehow all of the 4412d phone on our this 024tdl been assigned the adjuncts number instead of what was previously programmed. Is this an indication that this board is bad or how do I get out of this?

we have the MLX card and I'm able to make it dial out but is it not possible to receive calls in this setup. I've taxed my knowledge...help!

Thanks TouchToneTommy. I would alos like to know if we have to buy a "new" control unit or if we could buy the pcmcia card that will upgrade to r3.0. Our current card has a CKE5 proc in it.

Not so much the 2,0 but haveing to dial my extension number when I'm at my desk. We had Bellsouth Essx for a while and all we did was dial the messaging systems and enter our passwords. Thanks for the info.

We would like to upgrade our Magix system. We are looking for this option if is available and that is keeping a caller id history and getting away from the convoluted way to retrieve messages. We are currently running magix release 1 ver6.0 in hybrid/pbx mode and the messaging system is 1.1...

Thanks guys...I'll ask fir the MLX card and see if we can get this done.

We are trying to cut cost for the 4 BRI(s) we have. They cost over $400 a month. We were hoping that we could somehow steal a channel(s) and connect to our Cisco routers for ISDN backup.

Is it possible to setup one or more extensions as a BRI off of our Merlin Magix PRI? We are trying to eliminate the cost of 4 BRI(s) from our LEC.

Sorry for the delay but thanks again Tommy....I've setup the phones and everyone is happy.