Recent content by VivSavage

Thanks in advance for your help. I'm having trouble setting up VPNs between my PIX and two others. Following is the pertinent information (I think) from my PIX config. My internal address is 172.16.0.0 and the addresses for the other sites are 192.168.1.0 and 192.168.2.0. CompanyA...

I need to configure a VPN between Cisco PIX's at two locations. One site has a 506E version 6.2 with 3DES enabled. The other has a 515E version 6.1 w/o 3DES. I have acquired an updated activation key for the 515E which will enable 3DES. However, because of the IOS version, the installation...

Ouch . . . I was afraid of that. I guess I'll get pretty good with ACLs. Thanks for your help.

I have a situation in which 26 VLANs have been configured on a series of Cisco switches and they all feed to a Cisco router. For security purposes, the VLANs should NOT have any connectivity whatsoever. However, all the subinterfaces on the router are currently configured to use dot1Q...

Thanks PeterHurst and lambent for your help. Indeed, I had my access list 'bass-ackwards'. You've both earned my vote for tipster of the week.

Thanks for your response. Essentially, in this case, I need the router to route anywhere except between VLANs. Each VLAN needs to be isolated from all other VLANs. Can this be done and what's the best way to get there? Here's the config info on the interfaces: interface FastEthernet0/0 no...

I have inherited a series of 2950 switches and a 2600 router. Multiple VLANs are configured and are trunked to the router. The router has been configured with multiple IP addresses using subinterfaces with 802.1q encapsulation. For security purposes, I need to completely isolate traffic from...