Recent content by tyslep

The system will not allow me to set up a 911 dest code which is the first thing I tried.

I have a remote office with BCM 50. All inbound/outbound calls route via VoIP trunks back to the main BCM 400 using dest code 9. I have installed a CO line at the remote BCM 50 and programmed dest code 8911 to pull trunk 061 to dial out on the local CO. Easy stuff. What I'm having problems with...

qwebster, What other hardware/software/license would be required for 10 handsets. I already have access points in place.

Does anyone know of a cordless IP phone that will work on a BCM 450. I'm looking for a phone to work on the IP side, not on a digital or analog port.

The distance varies from 1 mile to 1.5 miles.

I have a customer who is moving to the BCM platform. They want to reuse several of their Polycom Conference phones (analog) The distance of the Conference phones is beyond the cable limits of a digital station. Is there a VoIP ATA for the BCM?

I'm wondering if anyone has used a Polycom Station 2-Nortel on a MICS digital port. Polycom's spec says it works on a Nortel Meridian and Meridian 1 digital port but makes no mention of MICS. Not sure if Meridian and MICS digital ports are the same.

Using copper trunks. WORKS! Interesting work around, I would never have thought of that one. Thanks

I have an ASM using for outbound faxes. I'm trying to pull Line Pool A without dialing the pool access code (9) The port is set for access to pool A, prime line set to pool A. When going off hook I still get system dial tone and have to dial 9 to access the pool. I have also tried assigning the...

I have MICS 6.1. When a held call ends up a the prime set (under lines) I'm trying to make a group of phones ring. I've tried assigning Answer DN of the prime set to the group of phones - NOPE. I tried creating a hunt group (707) and assign 707 as the prime set - NOPE the system won't accept 707...

thanks for the info. I konw that the customer has a pile of M-series phones, perhaps they swithed soemeting out.

BCM 400 In Element Manager under alarms I'm getting Alarm ID 401 (Core Telephony - Digital station loop initialization error.) every minute. The customer is telling me that all phones are working fine. Is this a station card acting up or an individual station. I don't look into the alarms very...

The 50's are all patched the same - no patches present. What area does the FEPS service handle? the VoIP trunks?

The patch on the BCM 400 (main office) is 4.0.2.03 and the 3 BCM 50's (remote offices) are at 6.0.2.05.237 Where in Eelment Manager do you restart FEPS service? Ty

I have a BCM 400 (Main office) with 3 remote offices (BCM 50's) connected via VoIP trunks. Inbound/outbound calls for all offices stem from the BCM 400 with a voice T-1. I have specific DID's routed to the remote offices. The following problems are occurring on 1 BCM only. The telco is...