Recent content by TyrantSSV

I think you have possible resource conflicts between built-in ports and ports on add-on card. Try to disable built-in ports and look what happened.

Yes of course. Some drivers does not support hibernation. Also check up free space on your disk - the HDD have to contain enough free space for HIBERFIL.SYS file which size have to be equal to RAM size.

NightOwll i440BX chipet have an integrated PCI IDE controller with no more than UDMA33 support. The native BIOS have HDD size limit at 32 GB, after upgrading the BIOS the limit will be 137 GB (may be; if you will found the new BIOS image). If the BIOS will be reflased you will be able to use...

greyowl71 Do you have the configuration utility for NICs? Sometime it's possible to run this utility in DOS with NIC installed and chande default settings in NIC's configuration flash...

Replace the fan or entire cooler.

To resolve the hardware conflict set back BIOS parameter "Resources Controlled By" to default (Auto) and try to install the new NIC in different PCI slots. Read information provided on screen as a PCI devices listing and check all devices and IRQ line used by each. Don't install the...

Using REGISTERED DIMMs influences on the full memory size, that is 1 GB RAM you can have only without memory controller's lines overloading. REGISTERED modules create much smaller loading and consequently using of them allows to use full capabilities of i440BX in addressing memory. i440BX...

Be sure correctly set the voltage switch on new PS (115/230 V).

Hi guys!!! Look here: http://developer.intel.com/design/chipsets/datashts/29063301.pdf (Intel® 440BX AGPset: 82443BX Host Bridge/Controller Datasheet) page iii: Integrated DRAM controller — 8 to 512 Mbytes or 1GB (with registered DIMMs) — Supports up to 4 double-sided DIMMs (8 rows memory) —...

You have formatted the second HDD width Adaptec SCSI adapter BIOS. It is LOW LEVEL format fro the drive, but not partition created. Run fdisk, select 2nd HDD and create partition. Reboot. The run Explorer, right-click on new disk (9.1 GB) and choose Format. After this you will be able to use new...

pmonett How much power your PSU produce? I think you need at least 300 W PSU. And disable Fast Boot parameter in BIOS - give to your HDD the time to be prepared to work.

Check the memory and, if bad memory found, replace it. To test memory visit to http://www.simmtester.com and download DocMemory Software. Make the bootable diskette as described in manual, boot from it and test the memory.

You can edit file boot in boot disk root.

First of all, check up the software, what port (COM1 or COM2, ...) it uses. Try to select another port it the settings. If it's impossible, check up quantity of ports in system. If your new computer has built-in video and only one COM port on the back panel, it doesn't mean the system board has...

Try to delete both monitors from device list and let the system to find one again.