Recent content by tschouten

Ok I'm experiencing the same issue. I have two identical web servers behind a couple of SSL Proxy/Load Balancers. I see the exact same thing as liquid2502. Right now until I resolve the issue with IIS I have to disable the node in my pool on the load balancer. I left the web server alone and...

Nevermind after contacting the company we were setting the tunnel up with I found they had supplied the wrong ip to my firewall in their firewall. Which completely explains what I was seeing. Duhhhhh....

I still can't see anything wrong with my configuration. The more I look at the information the less clear the problem seems. Would love it if anyone could shed some light here.

Yes...before someone makes comment I started to scrub out ip's then forgot the rest. Hey it happens when you get asked a thouand questions from people and you are trying to post at the same time. :)

For some reason I can't wrap my head around this issue. I have one of several site to site vpns that I can't get to negotiate properly. It is supposed to use sha but keeps saying it only has md5. I have set policies for both. The below is what I see when I run a debug. ISAKMP (0:0): sending...

You need IOS 12.2(13)ZG or higher to perform NAT-T on an 837. Hope that helps Terry Schouten

What is the site to site terminating to another pix?

In a sence, yes it will do the routing. Here is a quick rundown of how the pix works. Think of your interfaces as a set of stairs with multiple Landings. Say the Top Stair Landing is Security Level 0 (aka Outisde). Now say your bottom Landing is Security Level of 100 (aka Inside). And all other...

Funny thing is I can figure out how to get ospf,BGP and the like of that to work in a 50 router situation but this Firewall stuff stops me cold....makes me feel like a mental midget. (hope midget doesn't offend anyone...) Thank you all in advance.

I meant Now the problem is.....

Thanks I in fact did not have NAT-Traversal on the machine. You have to forgive me I am a router guy getting firewalls shoved at him. No the problem I have is when I connect with the client vpn it gets the routes its supposed to have access to but I cannot ping or access any device. I can ping...

I have the VPN client working however it doesn't route any packets. I notice an error in the logs portmap translation creation failed for protocol 50 src: dst: I have the vpngroup performing a split tunnel and I have sysopt connection permit-ipsec on the thing so I am sort of lost now. Any one...

Nine to ten odds it is an Outlook Client issue as most people have stated in here. Filters, AutoArchive, Rules, and yes those damnable PST files have been moved again if your using XP or 2003. Also if you use 2003 and someone marks an email important or flags for follow up they get moved into...

Ok I've just run into this problem as well. However it is very specific. It happens only when someone sends messages to Lotus Notes Domains. This is a known Lotus Issue, what happens is when a Rich Text, HTML, (any thing other than Plain Text) is sent out the attachment winmail.dat is sent with...

bebop1065 has a correct setup for NTP. He has the main router pointing to two servers as well as allowing two peers to quire the timing and allow for timing to disseminated. He basically stated what I did in a different way without making sure you check for the ports. Only reason I say to check...