EIGRP is not transported over MPLS. If you want your spoke locations to "see" EIGRP from the hub, you'll need to set up some kind of tunnel between the sites so EIGRP traffic can be exchanged.
I think your best bet would be the Motorola Canopy solution or even the new Cisco 11n bridges. They both run power over ethernet. You can use outdoor cat5 cable.
Proxim works well. Motorola Canopy units work well also. We have both solutions running, although the Proxim gear is rebranded Western Multiplex.
Check out Tessco's website. They have many different brands of wireless gear for different needs.
Hi.. I was just wondering if you were power over ethernet to power your IP phones or if you were using the power adapters. Just curious if POE is causing the MAC address to not show up.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.