Recent content by TomCat123

You wouldn't by chance know where I can get a proper manual for this old dog, would you?

Thanks Jerry... that works perfectly!

Thank you, * 7 0 + destination exteion results only in the call being put on hold. There is a problem here that isn't quite that obvious.

I have a Nortel Meridian 6x16 system with a very old firmware. System Version 30DBG04. I have a Norstar ATA part# NT8890AC-93 connected to one of the 16 lines. When I take a call on the phone connected to the ATA, I want to be able to transfer the call to another extension in my system, but...

This doesn't work either. Maybe I've been misinformed as to my version. In the system config, System version is reported as 30DBG04. Feature 70 + extension works for transfers coming from the M7208 phones - just not from the ATA's. Thanks so far for your help. I hope that someone has a...

A detailed description is in order. This is a Norstar Meridian with the Compact DR2 firmware. Line 1 thru Line 6 are all set as public lines with the prime set for each set to 24. Under call handling, I have direct to prime turned on and delay set to 1. There is an ATA on extension 24 with...

Something was just broken on this web site and my reply got misdirected. That was for a different thread.

So, for example, Flash *6623 should ring extension 23, correct? I try this and the phone just remains silent. Is there anything in the configuration of the extension on the ATA that must be in place for this to work?

Using an analog phone hooked up to a Meridian DR2 via an ATA, how do I access the following functions? : 1. A call comes in and I pick up on the analog phone - I want to manually transfer this call to another extension on the Meridian system. 2. A call comes in and I pick up the analog phone -...

Since the time of my last message I have finally received an email containing a DR2 manual in which I found a way to resolve this issue to my satisfaction. Thank you to all who read the question. If anyone can use a DR2 manual, please feel free to communicate that to me.

If this is not possible - what kind of device do I need to attach to my KSU in order to have an single-line analog device capable of receiving rings from any line that happens to ring?

If a call comes in on line 1 and the ATA isn't already occupied, I want the ATA to send a ring to the device attached to it. If a call comes in on line 2 and the ATA isn't already occupied, I want the ATA to send a ring to the device attached to it. Same goes for lines 3 through 6. 1 ATA. 6...

I have 6 phone lines, a Compact DR2 6x16, an ATA, and an analog auto-attendant system (non-nortel). I programmed the line access for the ATA extension to include all 6 lines. I programmed the ring to be on for all 6 lines for the ATA extension. The only time the ATA sends a ring to the...

I have 2 ATA units that I bought used on eBay but they didn't come with any manuals. Is there a resource somewhere that I can access this at? I've tried Nortel's site and can't even find so much as a product sheet there for these units.

Is it possible to at least get devices on the ATA's to receive a ring from the ATA for all of the 6 incoming phone lines? Currently, I have all 6 lines configured for each ATA under line access and have ring turned on for all of them, however, plugging a standard telephone into the ATA shows me...