Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Wanet Telecoms Ltd on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Theredone
-
Phaser 850 DP out of alignment
i'm so stupid i tried what marty said i was sure that the plug was in the same spot it always was but when i moved it to the top it worked and is printing fine. i did have to tape it in dose anyone know what hte part# is for one of these i would like to order a new one.- Theredone
- Post #4
- Forum: Printers General Discussion
-
Phaser 850 DP out of alignment
Thank you for the idia but it even dose it from the add-on paper tray that is just leter.- Theredone
- Post #3
- Forum: Printers General Discussion
-
Phaser 850 DP out of alignment
We have a phaser 850 PD that had jamming problems. and as i found out on this form we needed to replace the maintenance tray and the clutch witch we did. and it now prints with out jamming. but it about 1/2 an inch to low and that last 1/2 an inch is off the page can anyone tell me how to fix...- Theredone
- Thread
- Replies: 4
- Forum: Printers General Discussion
