Recent content by thatMISguy

Jhenke, OzzieGeorge and Carlosmj, All of you have been very helpful in regards to my original posting and my second posting. I'm glad to say that all is working well and I hope that we'll all be able to help one another in some way in the future. Thanks for all your help. that(grateful)MISguy

this is what happens... I, 1. ENTER feature conf * feature conf # redial (it suppose to say command =) 2. ENTER 200 recall ( 200> ) 3. ENTER the number of the code you want to use to clear the MWL LED ex. 64 and then recall (200>64-) when I press A14...

Carlos, When I enter the available code i.e. 64 and enter A146... when I get to the 6 key before pressing the CNF key it gives me an error saying digit error.????

OzzieGeorge, I went into CMD 200>A146 and this is what is displayed: 200>A146:WRONG- how do I clear it from what is programmed there already? I tried 200>A146:WRONG- CCC CNF(EXE).... same result.

OzzieGeorge, this must be done at the station or can it be done from the phone with the LED/Cat mode using the ext of the line in question? The phones at the stations are 8 button phones without LED displays. I wouldn't know where to begin to do the prgramming from the actual problem phones.

jhenke I tried speaker * 3 3 speaker, that didn't work. I tried >9000 ext. , 09 CCC-. That did not work as well. Do you or anyone else have any other suggestions using CAT mode? Any help is greatly appreciated

Henke, You're the greatest!!!! It worked exactly as you directed. If I may ask you one other question...some phones have the blinker for voicemails lighting up, but when we call the voicemail, it says there are no messages. How do I corect this? that(grateful)MISguy for JHenke's help!!!

Jhenke, No, I do not know how to change this using CAT mode. CAT mode is through the phone with the LED display right? I would just like to turn off the ringing, but if I could cancel the simultaneous ringing altogether, that would be even better. I have a partial manual but don't understand a...

I don't know which software is being used, but I'll check today. I also have the phone with the display. I fooled with call forwarding but that's not the solution. i.e. When ext. 1212 is called, line 1 on 1212 rings, simultaneously line 1227 rings on line 7 and vice versa. I hope I'm explaining...

I'm new to PBX systems. When one extension is dialed, a different extension rings as well. How do I stop it from ringing at the 2nd extension??? I have the manual but can't figure out how to execute the commands or which command controls this function. I have the NEC NEAX 2000 IVS. Any help will...