Recent content by telecomteen

Hi, I have about 500 1120E and 1140E IP sets connected to a CS1000E. The network topology is flat, all phones share the same subnet with over a thousand computers and other network clients. Recently, the phones are not registering correctly with the node when they are rebooted or newly...

Is there a repository for patches? I'm an IT guy and our company isn't a Nortel partner and we don't have access to download patches, but I do manage the BCM. Any ideas?

That's what I orignially thought, but I've disconnected the CO line from the Norstar's CO block and plugged it into an analog phone and it still doesn't work?

Not specifically tied to the Norstar persay, but... I'm an IT admin for a company that has a Norstar CICS 6.1 with a single GS/CLID cartridge. Our receptionist noticed that Line004 went dead today after a thunderstorm. No dial tone, and calling in from the outside gets a busy signal...

anyone please?? is it just that they can not be purchased in the US? any ideas??? thanks millions! - Matthew

Hello, Does anyone know where I can purchase Dialog Analog Sets (specifically the 4186) in the US? I can't seem to find a distributor... Thanks for the help! -Matthew

Hello all, We are converting our office (previously on Meridian Digital Centrex) to VoIP. We would like to continue using the MDC phones (digital.... i believe Aastra) with SIP ATAs. Here's the question: I know of products that allow for analog devices to connect to a MDC phone, but what...

Hi Brian, Thanks for the info. I was dialing the line number itself (061) - which obviously wouldnt work ;-) Stupid me! I'll try it with the rec'd digits - I'm sure it will work. Thanks for your help - Matthew

Hello everyone, I have setup a loop auto-answer line that gives me a dial tone when I call it. When I try to dial a Target Line, I get a fast busy. Feature codes DO work, as well as access to Line Pools. Why can't I dial a Target Line? System is CICS 6.1 w/ CP 2.0. Thanks, Telecomteen

Hi everyone, I need to setup my CICS (6.1) with Call Pilot 100 R2 to do a time-based after-hours call forwarding to an external number. Currently, we have an AA answering these calls during non-business hours, however, we need to direct incoming calls to an 800 number for answering after...

Does anyone know if a Legend R7 in key mode will light the MWI on the MLX phones if a CO line has telco voicemail? I haven't tried this to see if it works, but was just curious if anyone ran into the same question! Thanks, Matthew

Hi everyone, Oddly enough, the company that I do IT consulting work for just opted to purchase a refurbed Legend to replace an aging Vodavi PBX. I've been designated to handle all of the programming and install of the Legend, so needless to say, I really don't need a lab system anymore! I may...

Hey telecomtekperson, thanks for the post. I'm looking for an older processor, 408 GS/LS (no CLID), and obviously a carrier / PS. Thanks, Matthew

Thanks for the replies thus far. I really appreciate them! Merlinman, I'm in SW Wisconsin, if you may know any vendors in the Madison, WI or Chicago area. I know its a longshot, but it would be really great if any vendors could help out on the equipment, even if the processor is an old...

Hi everyone, I'm 18 years old, and have been bitten by the 'telecom bug'. I recently got the opportunity to install a Nortel CICS for a local small business. Now, I'd like to get some experience on some larger PBXs, such as a Merlin Legend or a small Definity. Since I live in a small area...