Recent content by teknoguy

i did a copy run start and i still get this message. here it is again. %SYS-4-CONFIG_NEWER: Configuration from version 12.2 may not be correctly unders tood %SYS-6-BOOT_MESSAGES: Messages above this line are from the boot loader.

I found that my router IOS doesn't support PPPoE.(12.2(17) at least i think it doesn't, i may be doing something wrong. Also, I spoke with my ISP, they said they're using PPP. They didn't say anything about PPPoE. Is it still possible to connect to my ISP with my 1605 router with standard ppp...

I am using a 1605 router.I upgraded my cisco IOS to verion 12.2(17) when the router reboots I get this: %SYS-4-CONFIG_NEWER: Configuration from version 12.2 may not be correctly understood what does this mean?

another thing. do i leave the cell properties at pixels and switch table properties to %?

is it standard practice to use percent instead of pixels? do i set the width or the height at 100%?

I am almost finished developing my website. I designed it in 1024 X 768 resolution mode. When I switched my computer to 800 x 600 i found my webpage to be jumbo sized. is there any magical way to reduce it to 800 x 600 without redesigning the page. I want to have both resolution types running on...

Another thing is, companies are beginning to use VPN's to connect each other instead of using frame relay. I just don't the big picture, why would they do that?

Hi..got it fixed. thanks. the problem was with my wiring configuration and with a setting on my LAN NIC- apparantly i don't need to enter a default gateway on my internal NIC.

Is frame relay cheaper, more reliable, more efficient then getting a ADSL business package. As mentioned above I can get that business package for $150 /month. Do get frame relay services from an ISP?

I also saw this ROM: System Bootstrap, Version 12.0(3)T, RELEASE SOFTWARE (fc1) what exactly is the system bootscrap version. does my 12.2(17) over ride that version?

This is my ISO version. Copied from show version. Cisco Internetwork Operating System Software IOS (tm) 1600 Software (C1600-Y-M), Version 12.2(17), RELEASE SOFTWARE (fc3) Copyright (c) 1986-2003 by cisco Systems, Inc. Im pretty sure it supports PPPOE, but not 100%. If you have a config that...

What is the main reason to go with frame relay, ATM, X.25. I understand that its used to connect sites together(WAN). But why not go with ADSL. I can get a ADSL business package with 5 static IP addresses, 15 GB/month Internet connection traffic, (10 GB/month down, 5 GB/month up.

I have two PC's and one hub. Main PC: XP pro with 2 NICS (same brand) 2nd PC : XP pro with one NIC All I am trying to do is share my internet connection. I am having a hell of a time setting up internet sharing with ICS. so I decided to used Sygates Home Networking software. It seems to work...

Would I need to set any encapsulation? or routing commands?

Hi.. it seems like we are doing exactly the same thing. Im using a 1605 router though. Hear is the link thread557-684044 adding this comment: access-list 1 remark used for nat I noticed you are using RIP ver 2. Do you need that statement for the internal LAN to get out?