Recent content by technickelone

Is transferring the end user software license from a decommissioned Avaya G3 to another allowed? Technickelone CCNA

Are there any guru's that can help me with a report. I'm trying to get a really accurate 30 minute increment report for hte number of agents in avail status, not staffed for the split/skill summary interval report. I use version r15. I'm trying to show starting at 7am to 7:30am there were 2...

How do I change what extention option 2 rings to when calling the main number? BCM 400 CALLPILOT Technickelone CCNA

We have a group of 6 PRI's from carrier "A" that handle our inbound 555-3000 DID service and first choice for outbound as well. We have 2 PRI's from carrier "B" that are in the same route in our PBX incase carrier A goes down. Then, only outbound calls will work and inbound gets a busy. If I...

Thanks for all the help. Again it doesn't work. I don't even have an option to print odd or even. When i choose manual duplex it prints page 9 and thats ALL. It tells me to flip the page over and put back in, and I do then hit OK and nothing happens. I'm sure you are all right so I am...

Since this is a printer I mapped to from the network I don't think there are drivers or software loaded on my pc to allow this. All options so far are not working. Technickelone CCENT

I have an HP lj 4250 and don't see this. Its at work and when I select manual duplex it prints a single sheet. Technickelone CCENT

The back of each sheet is the opposite of the other, like twisting it around. I have an option to check manual duplex but it only prints one page and its page 9. I put the sheet back in the printer and hit ok and nothing happens. Technickelone CCENT

Sorry for the delay in getting back, had to leave yesterday, not used to such quick responses. In word 2003 I set the page setup to book fold and the sheets per booklet to auto. My goal is to stack the manual and fold in the middle with a center staple. Just like a book. I searched for booklet...

When I start a booklet project in word 2003 I can't seem to figure out why the back of each page the content is upside down. I think if it was flipped around it may also fix the sequential numbering as well. None of the previous posts provide help nor google or microsoft. I need someone with...

Where is the setting to prompt the caller that I am on the phone. If i have two mcr keys set on key 0 and 1 it doesn't seem to prompt the caller I am on the phone. Is it that when the call rings my second line and i don't answer it just goes to vm under normal circumstances. Technickelone CCENT

nevermind, i had to finish the recordings Technickelone CCENT

I built and application in AB but Callpilot does not see it in the SDN menu when I go to link it. What am i missing? Technickelone CCENT

Ciscoguy, I didn't even think of interrupting the connection. The wife may get a little bothered by that so maybe I will just feed a cable over for access and nothing else until I master this. I look forward to learning this. Just passed my CCENT and getting a little eager.

Well for now I may just have to do with what I have. I guess I could feed directly into a router fast port