Recent content by techie211

2950

thanks but that link only mentions routers. does the same apply for the switch? and can I backup the config without privilege mode?

the network admin I replaced didn't leave any password info on the district switches so we're going around and recovering the passwords via cisco's site with reboot. This one switch we cannot change the password using the steps cisco recommends and it's displaying 'the password-recovery...

thanks for the link[thumbsup2]

hey ppl, I have a 2651 router and 2 2950 switches. I'm learning about vlans and trunking and would like to know how to set this up or even if the equipment I have is capable to handle this setup. I'm trying to simulate this setup. 2 - Win2k3 servers(one on int fa0/1 and one on int fa0/2) 1 -...

hey all, I'm hoping someone can explain to me what some lines in the config below mean. The one that starts with; a) 1 Ethernet/IEEE 802.3 interface(s) Unrecognized interface... Someone at work ran the 'erase flash' and 'erase start-up', I think those are rite, to remove any previous...

Hey ppl, is it possible to assign an ip address to a single port on a 2950? If so, how? I go to the interface config mode, but 'ip address' command doesn't work. We have a lab at our school that has 192.168.4.x running which is seperate from our network which is 10.10.20.x. But there is a...

hey ppl! I'm new here. HOpe my first post is a successful one. My infrastructure consists of 3 sites, one domain, all win2k(servers & workstations), nothing fancy!. Up until recently everythings been fine. But for some reason now 'all' the workstations are having a problem just connecting to &...

hey ppl! I need for the users to change their passwords once a month but they're getting the 'You do not have permission to change your password' error message In their accounts properties, I have User must change password at next logon cheched on and everything else checked off. They do get...