Recent content by tech32001

Josie, In your RDB under ISDN I think you need NCNA (network name allowed) to be YES. Also, I think NCRD (network call redirect) should also be YES.

My terminal at the carrier remote end is logging in the host mode ok but I'm just getting ??????? when it tries to connect to the TTY. We recently upgraded to Succession 3.0. We were told we had no site specific patches but I'm thinking maybe we did. Does anyone know of a patch for this?

Hey guys. Thanks for your input on this. It turns out I needed a feature package #307, Call Page Network Wide. You get a prompt in the RDB, NACC. It's specifically for accessing paging over a tie route.

I'm trying to dial the ACOD of a paging route from one site to another over tie lines. The tie lines have a D- channel. There are no tgar's or targ's involved, ncos and frl's are fine. I tried an acd queue ncfw to acod, fast busy. Tried fdn on an analog tn, continues ring. These are sent via...

Thank you both for your input. I hadn't known at the time but this MOV also corrupted data. I INIed to free up the tty and did a parallel reload to clear the corrupt data. Thanks Again

I moved a card in ld 25. It moved ok but now my tty will not communicate with the PBX? It prints what the PBX sends it, but does not seem to receive commands from the tty.

Nortellian is right. The DN must be in the VSDN table as an announcement service. Get it out of there and delete the announcement also.