Recent content by tdpandya

It can be a station card

Nice, so when system needs warranty we send it New Zealand??

Give me ur email I can send you some screen shots.

digital bay.

yes,We called ATT to verify the trunk. They came & did it.

digital interface card has a yellow tab.

I don't see any tone control card.

panadabear1, There is no receiver card that I can see. THere are 10 line circuit cards (9110-110),two Digital interface cards (yellow tab) scanner card (orange tab)& a peripheral card (red tab) in the bottom self & 2 co trunk circuit cards 9110-211-000 & a trunk circuit (4 trunk) card 9110-011 &...

Thank you kwbMitel.My bad. Yes it's sx-200 with rev.217. The cabinet has a two digital interface cards 9108-002-000. There is scanner card which has 9110-10-000 on it. How do I fix this problem?. Is it a bad card or programming?.DTMF tone is lost suddenly.No change on the trunk side. I really...

I am working on a old SX-200 analog/digital cabinet & customer lost dtmf dialing yesterday. Customer can receive calls but dials out on rotary.Check the trunk polarity seems fine. Any help would appriciate.

Problem solved. PBX is set up as follows. On MPR card & VOIP -DSP have an external static ip addresses.6 ip phones connected remotely. setup on sip trunk card( V-SIPGw16)as follows. under self property, turn off NAT TRAVERAL & leave the ip address blank.( leave everything as is). under card...

yes, tde 100 connected directly to cbeyond. using external ip with same range.( i have 5 external ips from provider).

I have 5 usable static ips from the carrier so I am using one of them.I also have tried port 5060 & 35060 both but still no luck. What would be the status of the sip trunk in the port setting looks like? it shows fault for the status. Thank you obtsystems for your feedback.

so the broadvox sip will only work thru dynamic natting? i hate to put another router just for this prupose.I would like to work of the Cebeyond router which is open for all traffic & since i have static ips that i can use. Any ideas would be appriciated.

I have a dsp16 card & has 4 sip trunk & 8 ip phone license. MY 6 ip phones which r at remote site works fine so i know that my public ips works. sip trunks are set to work off the public ip. do I to use a new ip address for the sip trunk or the one that i used on my dsp card card as a gateway?