Recent content by Syty

Uninstall the protocol from the properties of the network interface card properties.

I haven't had this issue from a pix before, but here are my thoughts... Hope this helps. Most obviously can the home user create a direct connection from the home network to the hosted facility? If not...Do you keep a local copy of the websites on the HQ network? If so, then have the user...

If you were local to the site you wouldn't log on to each machine individually, why would you configure a separate port connection for each remote PC? As far as your inability to connect to the first PC, what is your configuration at this point? Hanoi is on the money with site to site, but...

If you have a machine that is located on the remote site and unused, you can use it as a relay and remote to it. because it's on the private subnet you'll be able to use it to reach all other IPs. It'll be logically similar using a commserver type router when administering console objects on...

You'll need to know what "information" the continue button is passing to the server. Just add that command line or AsciiKey value that is generated when the command button (continue) is clicked. Adding that statement in the vbscript at the place will cause that "message window" close. The...

If you remove the gateway and it's an internal router, the user will not be able to route even the local subnet. We can't assume the architecture of the network.

You need to obtain the Resource Kit. In it is a the Remote Desktop Admin. You will run a very similar RDP (Remote Desktop Protocol) to do so. if you are trying to assist users from a remote workstation, you can always, configure NetMeeting, then deny 1270 and 1503 ports at the firewall to...

open gpedit.msc on the machien in question or connect remotely. You have many places a Group Policy can be defined. Looking at the Domain policy only shows the domain policy obviously. There are "Effective Settings" you want to pay attention to. gpresult is good for many things...

Wow....that's a lot of work to stop one person from hitting the internet. why not just statically assign his ip address, subnet mask, and gateway. Then reserve his IP like you would a server from DHCP -- Then add the following to your outbound access list on the router like the...

There are no student versions. You can however, give yoru flash to someone who has it and let them upgrade it, then move the RAM back into your router, (Not sure who's crazy enough to do that however) As far as the capacity, you can get 12.3.5a if you really wanted, but the tests are based on...

On a cisco router you can use the debug ip packet <access-list #> it's alittle cumbersome, but for specific tracking (not to be left on all day) you can assing an implicit permit access list for any given IP and then debug that Access list. You can use extended access lists to watch someone on...

If you are using a hub on your network, you will be just fine. If you are using a switch, you will not see the traffic taht is put off of another switchport due to separate Collision Domains Interconnecting Cisco Network Devices ISBN: 1-57870-111-2. Read about Broadcast Domains and Collision...

Menny, download a packet sniffer for that purpose. Most will allow you to track an IP or even a specific MAC as the source, or destination. I personally use EtherPeek for mine, but there are MANY

1-8 2-7 3-6 4-5 5-4 6-3 7-2 8-1 Rolled for cisco

It's not hyperterminal, what exactly are you getting on the screen? It works just fine on the other router, eliminates your misconfiguring HT, you have already verified your settings, and the cable is good. If you are getting the &quot;Press RETURN to get started!&quot; statement, then it's...