Recent content by systemkeeper

Guestworks, It did work on a Partner Messaging V1. After you enter the numbers (intercom 777,0#,password#,9,98925327) the lady says "The system will return to factory settings…….Goodbye". You have to wait about five minutes after she says goodbye before you can dial intercom 777...

pansophic, The Asterisk product looks like what I am looking for in an IP environment. I will have to pursue it further. The Vtech phones would work great and be less of a headache to set up but can I use three or four of the base units tied to one phone line? I have a 2.4 GHz spread spectrum...

I need a small (2-4 phones, 1 CO Line) wireless system to cover about a 200 acre field. It seems that I would need several wireless nodes to cover the area. AC Power is not a main concern for the nodes. I would like to use VoIP and a router or PC to control calls between phones and to have the...

Jlsniu, My info says pin 1 of the RJ45 will be the one on the left if you are looking into the female (card edge)with the notch down (gold pins up). Colors may not always be the same.

Hey itpphoneguy, It was an older VS system. Looks like it will be manual programming of that one.

itpphoneguy, I heard that sweet lady after putting in 18,19. The manual I was looking at said to use 22,23 if the VM card was in the first slot. Is this a typo or a differant system or am I missreading it? The front of the manual says Partner Mail VS, Voice Messaging System, release 5. I was on...

I had not heard of that rule. Dumb ACS. Seems it would know when a card and what kind is in it slots. It does when you remote in. Thanks, that cleared the yellow LED, but I set the ext (#505) to 22,23 they ring when dialed,no answer, dialing 777 will not pickup the sweet ladys voice that...

I have a Messaging R1 card that keeps the LED on yellow instead of green. I changed the card with a new one and the same thing happens. Whats up. I have two cards in the 5 card cage. ACS and Messaging in the slot to the right.

392 Can I connect to the unmarked LAN port and use the default IP address in the VM to connect with the AVAYA software? I am using the RS232 cable that I used to set up another card that had LAN printed on the top RJ connector. It worked OK. The card I am trying to set up now does not have LAN...

Are you connected to the LAN RJ connector or the RS232 connector? The RS232 connector should not be connected to a hub or switch. I played with this RS232 connector for several lost hours until TOUCHTONETOMMY gave me the pinout. My default settings turned out to be 9600 N81. I have one system...

Has anyone seen the LED's not light up when you program the number of ring's (blink,slow blink,fast blink)? I have about 15 exts and they all will program OK except for ext 11 which will not light up the LED's that show how the line will ring. All ext are set to no ring (except 11) so the AA...

What is the C01 at the end of the version number?

Telprog, I am afraid I have a group that want's everything done for them by the technology. I would get the complaint that it is not any easier to push an additional button than it would be to dial the *67. Thanks for the idea though. They are aware of the customer not answering...

Is there any way to have the Partner send *67 before every outgoing call without the caller having to dial it in each time?

I am not able to find the software portion of procedure above. Has the page changed?