Recent content by swozi2004

Feature 909 is the code for Register. Register as a supervisor and then hit feature 911 (for announcement maintenance).

Goto System Programming/Receiver Volume and change it from Use sys volume to Use set volume. Just to let you know, this is a system wide change and all phones will use this setting.

MRoberts - Where can I get ahold of that manual?

Does anyone know what this Event means? This was repeated 255 times.

A statement in the CallPilot 150 Rel 3.0 CD says "Note: If you are using the Auto-Attendant, only 200 mailboxs are supported". Does this mean if you use the Auto-Attendant at all, only 200 mailboxs are supported or if the Auto-Attendant answer's the lines on 0 rings? Tks.

Hookup an ATA to the system. Then take the output of the ATA and attach it to a spare line in the system. Setup the voicemail to answer on 0 rings for the line.

Has anyone had Set Relocation not work? I have a customer that has a MICS with 6.1 software & I tried moving a phone and the extension did not move? Tks.

Remove the battery on the board. Leave it out for a couple of minutes and solder it back on. I have done this several times and it works.

No, it is not possible. The page will not interupt the phone call. Sorry.

I was told there is a battery on the main core and a battery in the sleave. Is this true? I think the best thing to do at this point is see the customer a used MICS & toss the 8x24.

Thanks phoneguy427. I have asked this questions many times and know one new the correct steps. Guess I will have to have 6.1 (both MICS & XC) on hand when I upgrade to 7.0.

It's an 8X24 DR5 and the cartridge is either new or rebuilt (im not sure which). Could the cartridge be defective?

I have a customer with MICS 2.0 software and they want to use their GOLDMINE database software with the Norstar system. I have never used the Norstar Unified Messaging, so I do not know if it is compatible. Tks.

I recently replaced the main "sleave" because the battery was not holding the programming after losing power. The system lost power the other day and it again lost the programming. Is the DR5 switch "on its last leg" or is there something else I should be looking at? Tks.

I have a customer that wants caller id (they have MICS 5.0). I know you have to wait for 2 rings for the caller id to come in from the CO. Do you see the caller id info before you pickup the phone? Also, after the call is picked up an transfered, does the person receiving the call see the caller...