Recent content by supertech2000

Ring voltage should be about 85 VAC riding on the -46 VDC.

Like Dexman says, buying an R6 processor would be a better option. Investing some money in your business for the phone system should be a top priority.

Did you set a password in #730?

The S8300 is administered through the services port at ip address 192.11.13.6. You may need to download some manuals from Avaya's support website.

Connecting a USB cd/dvd drive to the s8300 and rebooting with your software in the drive will give you the option to reload.

AC2, Winspm use to be available on the avaya support web site. I think the rel. 4 to 5 is the whole program, not just an update.

If metroline has R7's, wouldn't they just upgrade some to R8?

Try 407951235 for a Fujitsu 640 MB.

Avaya has used HP's and Dell's servers for a while. I think the DL360 is one of HP's servers used as a S8800.

Try "list configuration all" will show all assigned boards and ports that are programmed.

I think you can also use 4 meg card. The card has to be an Avaya card because it contains a special format. I don't think you can format any 4 meg card in windows and expect the Definity software to be able to use it.

TexasRedCMC is correct. The connection to the phone relies on gravity and its not a very heavy phone. Sometimes even holding the phone down with your hand works.

You are close. See below. This is looking into the connector on the board. gnd. gnd . . neutral . neutral . . gnd. gnd. phase . phase .

The comcode on your R4 processor comes back as "PAR ACS PROC MOD R1 REP" so it was probably upgraded to the R4. The comcode for the R6 is not a valid comcode. Can you recheck your numbers?

Nortel is sueing CTDI for allegedly selling Nortel used phones as brand new Nortel phones. See link below.