Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by sto933

  1. sto933

    SV9100 SIP trunk "Busy here"

    Hi everybody A customer with SV9100 (PRI + a lot of COs) would like to connect over SIP trunk with CUCM on another location. I did configuration according to manuals and informayion from threads here. There 4 SIP tunk licensies. SIPO trunk (in networking mode) seems to be up - I see OPTIONS...
  2. sto933

    SV8300 cannot set call forwarding

    That was it! Thanks a lot, it did really help.
  3. sto933

    SV8300 cannot set call forwarding

    Hello everybody All of a sudden its not possible to set any call forwarding on one extension. And its not possible to set forward to any destination - internal or external. Its not possible by PcPro or by MOT mode. In MOT MOT you get DATA ERROR message and in PCPRO - Some data canot be applied...
  4. sto933

    SV9500- Background noise sound for calls via E1 PRI Trunk

    Do ypu mean clicks heard on this recording? If yes then it sounds like sync slips to me. Does your system properly sync'ed with PRI provider?
  5. sto933

    Avaya IP J169 and Alcatel OXO device

    Could it be that MLPP parameters configured on the phone? As transfer is supported on 3PCC SIP FW in theory J169 should handle two calls at the same time. So release of 1st call looks like MLPP feature. So I would check: - latest OpenSip FW fot that phone - play with MLPP parameters in a file...
  6. sto933

    Avaya IP J169 and Alcatel OXO device

    That means SIP set disconnects the call. Any setting in the set for second call handling?
  7. sto933

    Avaya IP J169 and Alcatel OXO device

    Strange, an active call shouldnt be disconnected in any case. Check SIP traces on the set or on the PBX.
  8. sto933

    Incoming Call Blocking on a SV 8300

    1st solution is as proposed by bengi1234 - you could ask you carrier to block calls from certain numbers. 2nd you configure "CID call routing" - read this chapter in Configuration Manual. It's not straightforward "blacklisting" but does job well.
  9. sto933

    Weird calls SV8300

    Hi 3racefan3 Thanks for response. Not exactly like that, more complicated. There some IP-phones that use Closed User Group feature from Mobile Operator. PABX is connected to this operator with PRI and uses local 4-digits numbering. If person leaves his working place usially he forwards his...
  10. sto933

    Weird calls SV8300

    Hi Ozzie, Sorry for that, smb=somebody. CFA=CallForwardAll. ABout IP-phones - who knows? LAN-switch is faulty, power lost, patchcord is plugged out etc. Person calling that IP-phone does not know about switched iit off or not. The point is in that case he does not get busy tone but connects to...
  11. sto933

    Weird calls SV8300

    It's getting more weird. We checked with Mobile operator and found out that sometimes smb calls to switched-off IP-phones with CFA set. Such calls always go to extension B/ I checked CM50 and CM51 - nothing is configured there. How SV8300 decies that it should ring ext B in case of not-existent...
  12. sto933

    Weird calls SV8300

    Hi belevedere Yes, we did activated SMDR for this extension (let it call B-etenseion) and found weird calls bouncing between PTT and PABX. There was a call from route 2 to the extension A which is forwarded to route 3(mobile provider Closed User Group). This A number does not exists in CUG so...
  13. sto933

    Weird calls SV8300

    Hello there Customer complains that for a few weeks a guest room number (it's hotel) started to get sporadic calls. It could ring for a second or two, or long enough to answer just to find out that a person was calling another extension. So we checked all possible forwards - no forwarding to...
  14. sto933

    SV8300: how do activate a new punch down on 66 block and identify it's extension

    Hmm, try to search for MDB journal or how it's called down there - a document where all ports/boards/shelfes/cables/patch-panels are drawn with their inter-connections. On many old sites I did search for papers which were left by installers and was succesfull.
  15. sto933

    DIL trunk rings only twice on SV9100

    Hi IpgPaul649 Thanks for responce. OK, I will try that
See more

Part and Inventory Search

Back
Top