Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by STJVIT

  1. STJVIT

    SV8300 PCPro - UNIVERGE UM8000 - NEC Series DT700: WMI light will stays on

    Hello, I had previously opened this post a few years ago about the WMI staying on. The same incident is happening (outlined in the previous post), and was hoping to see about correcting this problem. I was able to run the following command, suggested in the previous post: ...use the MOC mode...
  2. STJVIT

    SV8300 PCPro - UNIVERGE UM8000 - NEC Series DT700: WMI light will not go off

    Unfortunately, I am not authorized to post a bkup of the dB... Oddly enough, after connecting to the dB in the GUI, I attempted to use the Command feature, but the Command window is not accepting input. In the GUI, I did try to set the feature code to A041 using *7, but when I go to the phone...
  3. STJVIT

    SV8300 PCPro - UNIVERGE UM8000 - NEC Series DT700: WMI light will not go off

    Thank you for your response. I am trying to determine how to find an unused code. Currently, I am not seeing any feature codes set in CMD 200 (see image). Is this the correct location for the CMD 200? I am a beginner on this system programming and navigation: I did search for MW Lamp...and...
  4. STJVIT

    SV8300 PCPro - UNIVERGE UM8000 - NEC Series DT700: WMI light will not go off

    Hi, We're having a persistent problem with the message indicator light not going out on one of our NEC DT700 phones. The system is SV8300 PCPro - UNIVERGE UM8000. I have removed the profile for the ext in the UM8000 admin portal to disable voicemail, but the red light indicator remains. Also did...
See more

Part and Inventory Search

Back
Top