Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by stillabdul

  1. stillabdul

    BCM50 T1 DID outbound

    Thanks.
  2. stillabdul

    BCM50 T1 DID outbound

    Ok, I got some assistance from them indirectly, and now we can use the lines to go out as well. If I configure the lines as: E&M Dial Mode: Pulse Signaling: Immediate I can make outgoing calls, but cannot receive incoming ones. If I change the signaling to Wink Start, then I can...
  3. stillabdul

    BCM50 T1 DID outbound

    OK Curlycord, It isn't the Nortel tech I need, but as DBrewsky suggests, I need to verify again with the telco. They have not been cooperative thus far, but I will give them another shot. Thanks.
  4. stillabdul

    BCM50 T1 DID outbound

    no busy, just a long dial tone, then the phone gives me 'not in service'
  5. stillabdul

    BCM50 T1 DID outbound

    I have actually done this before, but with no joy. I gave a phone access and then dialed 8. I got a dial tone, but dialing a number didn't stop the dial tone, and then if I recall correctly I got a busy tone after that.
  6. stillabdul

    Default VM Password on BCM 50

    Should be 0000.
  7. stillabdul

    BCM50 T1 DID outbound

    I have one of the lnes configured as E&M now, with Line Type as PoolB. Under routing, I have: Route Use Pool DN Type 001 B Public(Unknown) Destination Code 8 for Route 001 (SDT 8) I want to put the lines in a pool (B) and use 8 as the code to call out...
  8. stillabdul

    BCM50 T1 DID outbound

    Point taken. The carrier has said that they have allowed for outbound also. Trunk type: DID Line Type: DN:* Dial Mode: Tone Loss Package: Medium CO Signaling: Link Start Line Tuning Digit: 1 Auto Privacy: Yes Restrictions...
  9. stillabdul

    BCM50 T1 DID outbound

    I have a BCM50 with DTM module. Our service provider has supplied us with a T1-DID which works great for incoming calls. They also say that the T1 can be used for outbound calls as well. At present, we are using analog lines for outbound calls. I have tried to configure the lines on the T1 for...
See more

Part and Inventory Search

Back
Top