Recent content by Ste1234567

You need to set the port on the cisco that is cascaded with the 3com as a "default" port and not a desktop port. On my 2950's I do this through the web interface (make sure the port is marked as a grey square and not with a picture of a PC on it)

Hi, At the moment, I have just plugged one of the ethernet ports on the switch blade to a port on a bog standard 3com switch (which is also located on the 201.44.100.x subnet) for testing. There is just the one cisco router which routes between the 144.x and 100.x subnet - so there are 2...

Ok, been playing around with it some more. Set the global IP configuration to use default-gateway 201.44.100.1 (the cisco router for that subnet) However, I am not sure what to enter for the default-network - would this be 255.255.255.0 ? Or something else? I currently have this set at...

Thanks vipergg. I have done as you suggested and assigned the correct IP and subnet mask to interface VLAN 1. I forgot to mention we have 2 subnets here.. 201.44.144.x and 201.44.100.x, how do I go about setting the default router on this thing? I am still unable to connect to the switch over...

Hi Guys, Firstly, I am a newbie. So apologies if this is a silly question which does not seem to be clarified anywhere I have looked. We have recently took delivery of a Cisco Catalyst 4507R Chassis with the Supervisor Engine II + (WS-X4013+) running Cisco IOS. I have managed to connect to...