Recent content by stalker802

I know, that TN750 doesn't work on CM. Does TN2501 work on G3V8?

I did trace. Telekom provider was sending 9xxxxxxxx number instead of xxxxxxxx, so when call-disp button was pressed it dialed 09xxxxxxxx.

I programmed msg-retr button on phone. When i try to call missed number with call-disp button, it dials 9 and number. I need to change to 0 and number. Where can i change that?

I need to change Audix mailboxes to 3 digit numbers. I administered on Switch link admin extension lehth to 3, but when I type change machine, it shows 4. I cannot edit it. I am missing some commands, or what I am doing wrong?

Oh, working directory was bad. Now i'm gonna check, how it is working. I hope it will work like G150, not like small office.

Sun 21/10/2012 11:26:20 : Received BOOTP request for 00e007017e0a 192.168.42.10 ip401ng.bin Sun 21/10/2012 11:26:20 : Sending BOOTP response for 00e007017e0a 192.168.42.10 ip401ng.bin And nothing happens what should i do?

So i have to use G150 manager and IP401ng file, which i found in catalog?

Hi, what firmware files should be uploaded to G150? Does ip401ng fits for that?

The problem occured in these phones. Ringer cut off is activating automatically. And I cannot assign a button to deactivate it. I must remove the station and recreate. Also connection to PBX is very poor, it is dropping all the time.

I can enter any IP address of messaging, but I think it should be on the same subnet as processor ethernet. Am i right?

Actually i can check it through messaging administration, but it is still not enabled, cause I didn't entered Messaging IP address. I don't know IP address yet, and I want to check license file, how many ports are opened.

I just want to configure messaging on S8400. How I can check if it is enabled through license file?

Avaya 655A power supply PS-RGEN 1540 test fails with 36 or 34 error codes. What these errors means? There are no such erros in documentation.

Actually it was CA-TSC request set to as-needed. Now it is set to none. And i have no idea, what this thing does.

Trunk is up. From list tra sta same result: denial event 1220: Recovery on timer expiry D1=0x944 D2=0x66